Water Supply Connection; Fitting The Water Filter - Haier HRF-628A*6 User Manual

Fig.4-13
ArtNo.601-0010 - SxS 661-9 - Pipe to filter
Fig.4-14
ArtNo.601-0005 - SxS 661-9 - Securing the pipe
Fig.4-15
ArtNo.601-0014 - Pipe to BSP connector
Fig.4-16

Water Supply Connection

It is recommended to have this product installed by
!
a qualified technician.
Note: For further installation details refer to the instructions
• Pressure of the cold water supplied to the automatic
icemaker is between 0.15-0.6 Mpa.
• The water tube should be of an appropriate length,
usually 8 metres, and should be free of bends after
being inserted into place. If the water pipe is too long
ice and cold water content.
DO NOT connect to the water supply when the
•
ambient temperature is below 0°C, otherwise the
water pipe may freeze.
Always connect to the drinking water supply.
•
Keep the water pipe away from heat sources.
•
• The water filter is there to filter impurities in the water,
and to make ice clean and hygienic. It cannot sterilise
or destroy anything , so be certain to connect the water
pipe to a drinkable water source.
•
Automatic water system,do not manually add water.
•
If the ice maker is turned on but the appliance is not
connected to water,the ice maker will not work.

Fitting the Water Filter

Measure out and cut the length of pipe required from the
supply. Make sure that you achieve a square cut using a sharp
knife.
groove as shown (Fig.4-14).
Connect the end into the plastic adaptor (Fig.4-15). Screw
the adaptor onto a suitable ½" BSP connector water outlet.
Access the water valve assembly at the back of the
refrigerator. Push the pipe into the valve assembly
(Fig.4-16).
Open the wa
water pipe joints and allow the water to run until it is clear.
Comissioning the Water Dispenser
for 1 minute. Do not press for more than 1 minute to prevent
overheating of the pad activator solenoid. Cold water will
18
(Fig.4-13).