Preparing The Remote Control - Nokia Mediamaster 9200S Owner's Manual

Connecting to an analogue satellite receiver and a video recorder
• Connect one SCART cable between the TV set and the TV
SCART socket on the Mediamaster.
• Connect one SCART cable between the TV SCART socket on
the analogue satellite receiver and the SAT SCART socket on
the Mediamaster.
• Connect one SCART cable between the video
recorder and the VCR SCART socket on the
Mediamaster.
• Connect the RF cable from the RF output on the
video recorder to the TV aerial input on the TV.
• Connect the ordinary TV aerial directly to the RF input socket
on the video recorder (TV if no VCR).
In order to switch the signal from the dish between the ana-
logue and digital receivers, you need a Nokia Smart priority
switch (at A B in the diagram).
• Connect the coaxial cable between output A on the NOKIA
Smart priority switch (accessory) to the LNB socket on the
analogue receiver.
• Connect the coaxial cable between output B on the NOKIA
Smart priority switch (accessory) to the LNB socket on the
Mediamaster.
The analogue receiver must switched OFF when you want
to watch channels from the Mediamaster.
Without a VCR, you should connect as shown in
the diagram to the right.

Preparing the remote control

• Remove the cover on the battery compartment at the bottom
of the remote control handset.
• Insert the 2 x AAA (1,5 V) batteries, as shown in the diagram,
taking care to observe the + and - markings indicated inside.
• Replace the cover.
With Video recorder
VCR
Analogue receiver
Nokia Smart Priority Switch
Analogue receiver
NOKIA Smart
priority switch
B
A
B
A
GB 7