Table of Contents
Advertisement
First-time installation
General information
Once you have correctly connected the Mediamaster, you will also
have to perform a "First-time installation." During this procedure,
helpful information is displayed at the bottom of the menus.
The select button always confirms a selection within these menus,
and pressing it will take you to the next step in the installation
process. More than one value, however, often has to be entered in
a menu. First, make all the necessary changes. Then, confirm them
all simultaneously by pressing select.
• You can always go back to the previous menu by pressing back.
• Use the
buttons to move upwards and downwards from
one line to another.
• Use the
buttons to change settings.
• Use the number buttons on the remote control to enter numeric
values.
Switching on for the first time and start
• Plug in your Mediamaster and the "First-time installation" menu
is shown.
• Press select to continue with the channel search.
•
The menu will be shown as long as the Mediamaster is searching
for TV and radio channels.
All channels found will be listed on the screen.
NOTE: the search procedure may take a few minutes. You can cancel
the search at any time by pressing select. .
When the search procedure has ended, a message will tell you how
many TV and radio channels have been found..
• Press select to continue watching digital TV channels.
• Turn off the horizontal/vertical rows of folders you see
superimposed on the TV picture by pressing the back button on
the remote control. These folders are named the Navi Bars. More
about them will be described later in this user guide.
GB 10
Advertisement
Table of Contents
