AEG KS8400501 User Manual page 10

10 www.aeg.com
Symbol Submenu
6.3 Activating a heating
function
1. Activate the appliance.
2. Press OK to confirm.
3. Set the temperature. Press OK to
confirm.
6.4 Steam cooking
The water drawer cover is in the
control panel.
1. Press the cover to open the water
drawer.
2. Fill the water drawer with 700 ml of
water.
The water supply is sufficient for ap-
proximately 30 minutes.
CAUTION!
Do not put water directly into the
steam generator!
Use only water as the liquid. Do
not use filtered (demineralised)
or distilled water.
3. Activate the appliance.
4. Set the steam heating function and
temperature.
Set + Go
Extra time
Display Contrast
Display Brightness
Set Language
Buzzer Volume
Key Tones
Alarm/Error Tones
Service
Factory Settings
Description
When ON, you can activate this function
when you activate the Full Steam function.
Activates and deactivates the function.
Adjusts the display contrast by degrees.
Adjusts the display brightness by degrees.
Sets the language for the display.
Adjusts the volume of pre-stones and sig-
nals by degrees.
Activates and deactivates the tone of the
touch fields. It is not possible to deacti-
vate the tone of the On / Off touch field.
Activates and deactivates the alarm tones.
Shows the software version and configura-
tion.
Reset all settings to factory settings.
5. If necessary, set the function Dura-
tion or End Time
The first steam shows after approxi-
mately 2 minutes. An acoustic signal
sounds when the appliance is at ap-
proximately the set temperature.
The signal sounds again at the end
of the cooking time.
6. Deactivate the appliance.
When the steam generator is
empty, an acoustic signal
sounds.
When the appliance is cool, soak
up all remaining water from the
steam generator with the
sponge. If necessary, clean the
steam generator with some vine-
gar.
Let the appliance dry fully with
the door open.
6.5 Heat-up indicator
When you activate a heating function,
the bar on the display comes on. The bar
shows that the temperature increases.
.