Cleaning The Milk System; Cleaning The Brewing Unit - Siemens TI 903 Instruction Manual

Cleaning the milk system

The milk system is automatically
cleaned with a short jet of steam directly
after preparing a milk drink.
:
Warning
Risk of burns!
The outlet system becomes very hot.
After use, always let the outlet system
cool down before you touch it.
~ Fig. #, ~ Fig. &
Manually clean the milk system on a
weekly basis, or more frequently if
required. For particularly thorough
cleaning, the milk system can be
additionally rinsed with water. ~ "Rinse
milk system" on page 27
Remove the milk system:
Remove the milk container from the
1.
appliance.
Slide the outlet system to the bottom
2.
position.
Press the unlocking mechanism at
3.
the top right.
Fold the cover down towards the
4.
front and remove.
Remove the milk system and
5.
dismantle into individual parts.
Clean the individual parts with
6.
detergent solution and a soft cloth.
Rinse all parts with clean water and
7.
leave to dry.
Notes
All parts of the milk system can be
■
cleaned in the dishwasher.
Detergent residues in the milk
system must be thoroughly removed
following the rinsing process.
Important: The outlet system cover
■
is not dishwasher-safe.
Inserting the milk system:
Assemble the individual parts of the
1.
milk system.
Insert the milk system into the cover.
2.
Daily care and cleaning en
Slide the outlet system to the bottom
3.
position.
Position the cover at the bottom and
4.
pivot it upwards until it engages.

Cleaning the brewing unit

~ Fig. $, ~ Fig. (
In addition to the automatic cleaning
programme, the brewing unit should be
removed regularly for cleaning.
Caution!
Clean the brewing unit without detergent
and do not put it in the dishwasher.
Remove the brewing unit:
Switch off the appliance.
1.
Remove the water tank.
2.
Slide both red locking sliders
3.
towards one another and remove the
cover.
Remove, clean and dry the coffee
4.
grounds slider (red) and the brewing
unit cover (red).
Slide the red lock to the right across
5.
the brewing unit.
Carefully remove the brewing unit
6.
and clean thoroughly under running
water.
Clean the interior of the appliance
7.
thoroughly with a moist cloth,
removing any coffee residues.
Allow the brewing unit and the
8.
interior of the appliance to dry.
Insert the brewing unit:
Push the brewing unit into the
1.
appliance in the direction of the
arrow. The arrow is located on the
top of the brewing unit.
Position the brewing unit from
above, suspend on the guide rails
and push into the appliance.
Slide the red lock to the left across
2.
the brewing unit.
Insert the coffee grounds slider (red)
3.
and the brewing unit cover (red).
Insert the cover until it engages.
4.
Insert the water tank.
5.
25