Access Point Settings - Nokia Remote Camera User Manual

C o n f i g u r e t h e s e t t i n g s
When you have requested these settings, you are prompted to accept or
discard the new settings. To accept the new settings, send the
following text message to the camera:
99
To discard the new settings, send the following text message to the
camera:
88
Tip: If you are using Remote Camera Manager, select Settings >
Connection.

Access point settings

You only need to configure the access point settings manually if the
automatic MMS settings of the camera do not function, and your
operator does not support sending the settings over the air.
An MMS access point contains all the needed MMS settings. To create a
new MMS access point for the camera, start the text message with
40, and then add the following settings to the message:
• 1 connection name
• 2 access point name
• 3 user name for the access point connection
• 4 password for the access point connection
• 5 access point home page address
• 6 1 (normal connection authentication) or 6
connection authentication)
• 7 1 (connection security on) or 7
• 8 1 (temporary session mode) or 8
• 9 IP address of the camera or 9
select the IP address automatically
• 10 IP address of the primary name server
• 11 IP address of the secondary name server
• 12 IP address of the proxy server
48 Copyright © 2005 Nokia. All rights reserved.
2 (secure
0 (connection security off)
2 (permanent session mode)
0 if you want the camera to