FRONT SEATS WITH ELECTRIC CONTROL
Switch 3 is used for adjusting the seat-
back and switch 4 is used for adjusting
the seat squab.
On equipped vehicles, buttons 2 are
used to store the chosen driving posi-
tion (refer to the following page).
Adjusting the seat squab:
– To move the seat forwards or
Move switch 4 forwards or backwards.
– To raise or lower the rear of the
Move the rear of switch 4 upwards or
– To raise or lower the front of the
Move the front of switch 4 upwards or
Adjusting the lumbar support
on the driver's seat:
Lower handle 5 to increase the support
and lift to decrease it.
For safety reasons, carry
out any adjustments when
the vehicle is not being
Adjusting the seatback:
To tilt the seatback, move the top of
switch 3 forwards or backwards.
(depending on vehicle)
With the engine running, turn control 1
to either position 1, 2 or 3 (depending
on the temperature required). An indi-
cator light on the instrument panel lights
up once the front seat heating system is
The system, which has a thermostat,
decides whether or not the heating is
needed, according to the position se-
We would advise you not
to recline the seatbacks too
far to ensure that the effec-
tiveness of the seat belts is
Nothing should be placed on the
floor (area in front of driver) as such
objects may slide under the pedal
during braking manoeuvres, thus
obstructing its use.