TOOL KIT/WHEEL TRIM - WHEEL
The tool kit is located in the luggage
compartment: lift the luggage compart-
ment carpet, remove the jack then un-
screw the central mounting. When refit-
ting, always clip the jack with flange B
Do not leave the tools unsecured inside the vehicle as they may come
loose under braking. After use, check that all the tools are correctly
clipped into the tool kit, then position it correctly in its housing: there is a
risk of injury.
If wheel bolts are supplied in the tool kit, only use these bolts for the emergency
spare wheel: refer to the label affixed to the emergency spare wheel.
The jack is designed for wheel changing purposes only. Under no circumstances
should it be used for carrying out repairs underneath the vehicle or to gain access
to the underside of the vehicle.
Fold it and position retainer A correctly
before refitting it in its housing.
Towing hitch 2
Refer to the information on "Towing" in
Hubcap tool 3
This tool is used to remove the wheel
Allows the wheel bolts to be locked/un-
Wheel locking nut
Locations are provided in the tool kit to
Remove the wheel trim using hubcap
tool 3 inserting the hook into the open-
– near valve for wheel trim 5;
– around the perimeter for a central
To remove wheel trim 5, align it with
valve 6. Push the retaining hooks in
fully, starting with side C near the valve,
followed by D and E, finishing at F op-
posite the valve.