Table of Contents
Advertisement
Stubborn soiling on the
FlexiClip runners
Do not wash the FlexiClip telescopic
runners in the dishwasher. This will
remove the special lubricant which is
essential for their smooth
functioning.
For stubborn surface soiling or if the
bearings become sticky proceed as
follows:
Soak the FlexiClip runners for approx.
10 minutes in warm water and liquid
dish soap.
If necessary, use the rough side of a
dish sponge. The bearing can be
cleaned using a soft brush.
After cleaning discolorations or lighter
areas may remain on the runners. This
will not affect the performance in any
way.
Cleaning and care
Cleaning the catalytic
enameled back panel
Soiling from oil and fat is burnt off
catalytic enamel when very high
temperatures are used in the oven.
The higher the temperature, the more
effective the process.
Exposure to scouring agents,
abrasive brushes or sponges and
oven sprays can cause the catalytic
enamel to lose its self-cleaning
properties.
Catalytic enameled panels should be
removed before using oven spray.
Removing soiling caused by spices,
sugar and similar deposits.
Remove the back panel (see
"Cleaning and care - Removing the
back panel").
Wash the back panel by hand with
warm water and liquid dish soap
applied with a soft sponge.
Rinse thoroughly and let dry before
placing it back in the oven.
63
Hide quick links:
Advertisement
Table of Contents
