Advertisement
F!(3.4
h-
2-1/,
22
-1-o
2?"
L
.
SHUTOFFVALVEHEREIF
RECWIRED BY LOCALREGULAT~Q~~
B
FIG. 5
Hyou are repiacing an older unit that had
a cutout
height
of more than WY' (39" to 39-3/8" are normal, aHernat@
standaf'd~) Wow
steps below:
1,
Measure by how much your cutout height exceeds 38".
2. Relocate and raise yourgas inlet pipe if necessary. See
figure 4. The 2-1/2" dimension (shown in figure 4) need
only change if yourcutout height is morethan 38-1/2". If
your cutout
height is more than 38-1/2", increase the 2-
1/2" dimension shown in figure 4 by amount measured
in step 1, above.
3. Remove the storage drawer (see Care and Cleaning
sectionof Use and Care Manual).
4.
Extend
the leg levelers (using a 3/16" hex socket driver
or a fIat bladed screw
driver)bythe amountmeasuredin
step 1, above.
3/16""
h
&
SLOTTED
HEX HEAD
; ,
/
I /
/
II
I
LEG
LEVELER
s, Insertthe oven in the cutoutand adjust leg levelersso
thatoven racksare Ievei(checkwith spiritlevelon oven
rack)andthe top of the controlpaneloverlapsthetop of
Ihe cutout.
6. Make electricaland gas connectionsand drive screvvs
through side trim as explainedon previOUS page.
7. Two lowertrimpieces arePr@Jided" l fyouhave@~tended
the leg levelers
3/4" or more, use the tal!ertrim. Attach
to the unit with the 3 screws supplied and to the cabinet
below with the 2 wood screws supplied.
It leg levelers are extended less Iban 3/4", use tkc-
Shorter trim.
Attach to the unit With the ~ SGJEW~-
.
supplied.
IL.!%
To adjust your oven for use with L.P. gas, follow the steps
below.
Step ~: Adjust Pressure F?egulaUJr
NOTEI:The pressure regulator issetfornat~ra~ gas. To
use L.P.
gas, the
regulator must be adjustedm
Locatethe pressure regulator(~ee Fig. 5). UnscreWthecaP
and
rernovethe
spring retainer, Fig. 6. T+urnthe retainer@Jer
and put it back into the cap so L.P. is showing on the bottom
end of the retainer. Replace the cap.
Step 2:
MjuSt
Burner OrificeS
CXWW3N:
The fdowing
adjustment must be made
before t~rnhlg on lhe burners.
Failure tO dQ SOc~u~~
result in serious injury due to high fkimes and toxic
fumes.
AFzm.
Use a
~/2JJOpenendoradjustabie
vurenc!l
totumbothc~fil:=:-. '-- .-
hoods in the L.P. direction, about 1-1/2 turns or until snug.-"—
See next page. Do not overtighten or you may distofl t
orifice hoods and needles.
~- ------
*Gregu'a
n
I
l-m
II
~—+
I-IL–-I
&qual to or less tban 1/2 psig.
Advertisement
