Canon VB-H43 Operation Manual page 72

Record] and (11) [E-mail Notification] will be executed
according to their settings upon an OFF event.
(8) [Ongoing ON Event Operation]
Select the operation to be performed while a volume
detection event is ongoing. This can be set when [ON
Event Operation] is set to [Enable].
Select [Enable] to perform operations according to
the (10) [Video Record] and (11) [E-mail Notification]
settings during an ongoing volume detection event.
(9) [Preset]
If a preset is specified, the camera will orient
automatically to the specified preset position when a
volume detection event occurs. To use presets, it is
necessary to set the presets with the Preset Setting
Tool under Admin Tools (p. 106). If there is no need
for additional camera operation, select [None].
(10)[Video Record]
Specify the video record action. If [Enable] is
selected, video will be transmitted to the destination
selected in [Video Record Action] (p. 71) when a
volume detection event occurs.
(11)[E-mail Notification]
Select the e-mail notification operation to be
performed. If [Enable] is selected, e-mail notification
is performed when a volume detection event occurs.
To use this function, [Upload] > [E-mail Notification]
must also be set (p. 68).
(12)[External Device Output for ON Event]
Select whether external device output (1 or 2) is active
or inactive upon an ON event. Select [Disable] to
disable external device output.
(13)[External Device Output for OFF Event]
Select whether external device output (1 or 2) is active
or inactive upon an OFF event. Select [Disable] to
disable external device output.
Important
• The volume detection function is temporarily disabled during
audio file playback and audio transmission from the viewer.
• For notes on use of volume detection, see "Safety
Precautions" in "Precautions for Use of Built-In Camera
Functions and Included Software" (p. 7).
• When Admin Viewer/VB Viewer has camera
control privileges, those camera control privileges are
released if the camera is moved to a preset position,
specified in the [Preset] settings, by a volume detection
event operation.
External Device Output
72
(1) [Operation Mode]
Select the normal (inactive) circuit condition.
When [Normally Open] is selected, the output
terminals remain in the open state during normal
operation, and the terminals close upon an active
event and open upon an inactive event.
When [Normally Close] is selected, the output
terminals remain in the closed state during normal
operation, and the terminals open upon an active
event and close upon an inactive event.
(2) [Active Output Format]
Select [Pulse] or [Continuous] for the external device
output format.
(3) [Pulse Output Time (sec)]
Enter the pulse output time in the range of 1 to 120
(sec.). This setting is available when [Active Output
Format] is [Pulse].
Important
When [Active Output Format] is set to [Pulse] and a timer is
used, a single contact output is controlled when the timer starts.
Note
[Normally Open] means that the contacts are normally in the
open state (that the circuit is non-conductive), and [Normally
Close] means that the contacts are normally in the closed state
(that the circuit is conductive).
Normally Open
Active Event
Inactive Event
Normally Close
Inactive Event
Active Event
External Device Input
(1) [External Device Input Event]
Set external device input events to [Disable] or
[Enable].
1 (Terminals close)
0 (Terminals open)
1 (Terminals close)
0 (Terminals open)