Shark NP320 Series Owner's Manual page 9

Hose
Dock
Fig. 6
Fig. 7
USE IN CANISTER MODE
6 Place the hose in the hose dock. (fig. 6)
7 Place the unit over the caddy and press down until
it locks into place. (fig. 6, fig. 7)
8
To release the vacuum from the caddy, press caddy
release button and lift the vacuum up. (fig. 8)
Fig. 8
FOR ADDED COMFORT OR FOR AN EXTENDED
REACH
9
Attach the floor kit handle to the flexible hose.
Push it in until it is secure. (fig. 9)
10 Insert the telescopic tube into the end of the floor
kit handle. Push it in until it is secure. (fig. 9)
NOTE: All accessories may be used with the
flexible hose, the floor kit handle or the telescopic
tube.
11
Attach the desired accessory to the end of the
flexible hose, floor kit handle or telescopic tube by
pushing it in until it is tightly secured. (fig. 9)
12
While holding the Canister Vac by the handle,
press down on the power button to turn the
Canister Vac on and begin vacuuming. Press down
again to turn the vacuum off. (fig. 5)
www.sharkninjamanuals.com
Caddy
Release
Fig. 9
8