When Connecting This Unit Mutually; When Inputting The Synchronization Signal From Another Device To This Unit; Configure The Settings Relating To The Electronic Zoom [Electric Zoom]; Image Freezing [Freeze] - Panasonic GP-US932CSXE Operating Instructions Manual

When connecting this unit mutually

Step 1
Set the synchronizing signal input/output selection switch
on the rear face of the master CCU to "OUT". Set the syn-
chronizing signal input/output selection switch on the rear
face of the slave CCU to "IN".
Step 2
Provide the synchronizing output signal from the synchroniz-
ing signal output/input connector of the master CCU to the
synchronizing signal output/input connector of the slave
CCU.
Select the same video format setting for both CCUs.
(☞ Page 11)
Step 3
Move the cursor to "SYNC" on the top screen of the SETUP
menu of the slave CCU.

When inputting the synchronization signal from another device to this unit

Step 1
Set the synchronizing signal input/output selection switch
on the rear face of the CCU to "IN".
Step 2
Provide the video synchronizing output signal from the mas-
ter device to the synchronizing signal output/input connec-
tor of this system.
Select the same video format setting for both units. (☞ Page
11)
Step 3
Move the cursor to "SYNC" on the top screen of the SETUP
menu.

!3 Configure the settings relating to the electronic zoom [ELECTRIC ZOOM]

Select "ON" (default) or "OFF" to determine whether or not to use the electronic zoom.
To prevent the electronic zoom from being active by mistake, select "OFF".
When "ON" is selected, assignment of the electronic zoom function to the [e] and [f] buttons allows users to scale up (up to
2.5 times) a subject by pressing the button. (☞ Page 31)
Note:
• Calling up the SETUP menu cancels scale up and down.
• When "ELECTRIC ZOOM" is set to "OFF", "ZOOM OFF" appears in the SEL menu, and the zoom function is not adjustable.

!4 Image freezing [FREEZE]

Selection of "ON" (default) or "OFF" determines whether or not to enable the freeze function.
When "ON" is selected, pressing the [FREEZE MENU ] button on the front face of the CCU allows users to display the video
currently displayed as a still image. (☞ Page 10)
Step 4
Select "EXT2", and then press the [SEL] button.
The "SYNC" screen appears.
→
Step 5
Provide the output signal in the same video format from
both CCUs to the oscilloscope to observe the horizontal
synchronization component.
Step 6
The horizontal phase is adjusted by pressing the [e] or [f]
button.
Step 4
Select "EXT1", and then press the [SEL] button.
The "SYNC" screen appears.
→
Step 5
Provide the output signal in the same video format from
both units to the oscilloscope to observe the horizontal syn-
chronization component.
Step 6
The horizontal phase is adjusted by pressing the [e] or [f]
button.
29