Supplied Accessories; Preparation; Charging The Battery Pack - ADI AF-16 User Manual

UNPACKING AND CHECKING EQUIPMENT
Welecome to use ADI wireless transceiver, we suggest
to take the following steps before use:
•Please check the packing box to see if there is any damage.
•Please carefully unpack the packing, and identify the items listed
below. If any items are missing or damaged, please contact the
dealer.

SUPPLIED ACCESSORIES

SUPPLIED ACCESSORIES
ITEM
Wireless Transceiver
Antenna
Lithium Battery Pack
Desk Top Charger
Adapter
Belt Clip
User's Manual
Warranty Card

PREPARATION

PREPARATION

CHARGING THE BATTERY PACK

CHARGING THE BATTERY PACK
The battery pack is not fully charged at the factory, please
charge it before use. Initially charging the battery pack after
purchase or extended storage (greater than 2 months) will
not bring the battery pack to its normal operating capacity.
After repeating the charge/discharge cycle two or three
times, the operating capacity will increase to normal.
QUANTITY
1
1
1
1
1
1
1
1
Please charge according to the following steps:
1.Plug the adapter into a 110V socket.
2.Plug the DC plug into the DC jacket located on the
back of the charger.
3.The charging LED lights green when the charger
is to be charged.
4.Slide the battery pack or transceiver with the battery
pack into the desktop charger.
5.Make sure the battery pack contacts are in contact
with the charging terminals. The charging LED lights
red and charging begins.
6.Afrer charging about 3 hours, when the light turns to
green, it means the battery pack is fully charged.
Then you can take off the battery pack or trans-
ceiver with the battery pack and use it.
Note:
1.Do not short the battery terminals or dispose of the battery by
fire. Never attempt to remove the casing from the battery pack.
2.Keep the charging temperature always between 0℃ and 40℃.
Charging outside the temperature range may affect the right
charging.
3.Do not use the transceiver while charging is taking place.
4.Do not plug or unplug power supply or battery pack, in order
not to interrupt charging porgram.
5.When even if charged correctly, the battery pack still cannot
return back to its normal operating capacity. If this occurs, it
means the life of the battery pack has nearly come to an end,
please replace by a new one.
6.Do not charge when the battery or transceiver are wet. Use a
dry cloth to clean them before charging in order to avoid
danger.
PREPARATION