Putting Into Operation; Switching On And Off - Bosch GCO 2000 Professional Operating Instructions Manual

Cut_off and miter saw

Hide thumbs Also See for GCO 2000 Professional:

Original instructions manual (325 pages)

Original operating instructions (82 pages)

Operating instructions manual (26 pages)

Table Of Contents

Table of Contents

Available languages

24 | en

Changing the Tool

(See the Illustration A and B)

Before all work on the machine, pull the

power plug.

Use only cutting disks that correspond to the

characteristic data given in these operating

instructions.

Use only cutting disks whose allowable speed

is as high as the no-load speed of the machine.

Actuate the spindle lock only with the cutting

disk is at a standstill.

Removing the Cutting Disk

Place the machine in the working position.

Pull lever 19 upward and slide it alongside the

guide groove.

This pivots the retracting blade guard 14 upward

to the stop, where it is held in the open position.

Loosen wing bolt 17 and swing the cover lid 18

toward the rear.

Turn the hex-head bolt 24 with the wrench 8 (5

mm) provided while pressing the spindle lock

15 at the same time until it engages.

Hold the spindle lock depressed and unscrew

the hex-head bolt 24. Remove the washer 23

and the clamping flange 22.

Remove the cutting disk 20.

Installing the Cutting Disk

If necessary, clean all parts to be mounted.

Place the new cutting disk on the tool spindle 21

so that the label points away from the tool arm 3.

Place on the clamping flange 22, the washer 23

and the hex-head bolt 24. Press the spindle lock

15 until it engages and tighten the hex_head bolt

24 with a torque of approx. 18-20 Nm.

Swing cover lid 18 toward the front and tighten

wing bolt 17 again.

Slide lever 19 downward alongside the guide

groove again and at the same time swing the

retracting blade guard 14 downward until the

lever engages.

F 000 622 257 | 12.2009

Adjusting the Miter Angle (See the

illustration B)

Before all work on the machine, pull the

power plug.

The miter angle can be set in the range from 0° to

45°. Often used setting values are identified on

the angle stop 13 with appropriate marking. The

0° and 45° positions are set at the end stops.

Loosen the two angle stop bolts 7 with the open-

end wrench 8 (13 mm) provided. Set the desired

angle and retighten the angle stop bolts.

Clamping the Work Piece

(See the Illustration C)

Before all work on the machine, pull the

power plug.

To ensure optimum working safety, the work

piece must always be firmly clamped.

Place the work piece against the angle stop 13.

Slide the clamping spindle 12 against the work

piece and clamp the work piece firmly with the

aid of the spindle 10.

Releasing the Work Piece

Loosen the spindle handle 10.

Swing up the quick release 11 and pull the

clamping spindle 12 away from the work piece.