Rinsing The Iron Steam Chamber; Cleaning And Maintenance; H Storing The Appliance - Bosch Sensixx B45L Operating Instructions Manual

indicated in the picture b). Then, rinse it again with
water (very important!).
The descaling fluid can be obtained from our
Aftersales Service or Specialist outlets:
Accessory code
(After-sales)
00311715
7. Holding your steam generator in the lateral
position and using a jug, fill the boiler with 1/4 litre
of water and replace the filter.
8. Shake the base unit for a few moments, unscrew
the filter again and empty the boiler completely
over a sink or bucket.
For best results, we recommend that this
operation is performed twice.
Important: before re-closing, make sure no water
remains in the boiler.
9. Replace and tighten up the filter.
To reset the "Clean" counter, switch the station
off twice, keeping it off for at least 30 seconds
each time.
(on → 30s off → on → 30s off → on)
Rinsing the iron steam
g
chamber
E
Caution! Risk of burns!
This procedure helps to remove scale particles from
the steam chamber.
This cleaning procedure may be performed
occasionally (approximately once a year), when after
a long period of use with very hard water, scale
particles start to come out of the soleplate.
a) Ensure that the iron has cooled down.
b) Fill the tank with tap water.
c) Plug in the mains cable and set the main power
button (9) to the "I" position, (illuminated in red).
d) Set the temperature to the
e) Set the steam setting to
stops flashing.
f) Hold the iron over the sink or a container to collect
the water.
g) Press the steam release button (13) and gently
shake the iron. Boiling water and steam will be
released, carrying scale and or deposits that
might be inside. This could take approximately 5
minutes.
h) Set the temperature to the
pressing the steam release buttons (13-14*).
The water in the steam chamber will start
evaporating. Wait until all the water inside the
chamber has been evaporated.
i) To clean the soleplate, immediately rub off any
residue by running the hot iron over dry cotton cloth.
Name of accessory
(Specialist outlets)
TDZ1101
setting.
and wait until the icon
setting, without
Cleaning &
Maintenance
E
Caution! Risk of burns!
Always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
1. After ironing, disconnect the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cotton cloth.
3. If the soleplate is soiled with dirt or scale, clean it
with a damp cotton cloth.
4. Never use abrasive products or solvents.
H
Storing the appliance
1. Always allow the appliance to cool down before
storing it.
2. Set the main power button to the "0" position (the
red light will go off) and disconnect the mains
cable.
3. Empty the water tank.
4. Place the iron on the iron pad (2), standing on the
soleplate, and fix it by inserting the tip of the iron
into the front slot and moving the fixation system
lever (10) against the heel of the iron.
5. Store the mains cable (5) and steam hose (6) in
the storage compartment (4). Do not wrap the
cords too tight.
6. Hold the iron´s handle when moving the
appliance, as shown in figure H, or use the
carrying handles (3) on the sides.
21
BOS CH