Brother HL-S7000DN User Manual page 90

General Information
Network Menu
Submenu 1 Submenu 2
Wired LAN TCP/IP
Ethernet
Wired Status -
MAC Address -
Set to Default Restores wired network settings of the internal print server to the factory default.
Wired Enable -
The factory settings are shown in Bold with an asterisk.
Menu Selections Options
Auto* / Static / RARP /
Boot Method
BOOTP / DHCP
IP Address ###.###.###.###
(000.000.000.000)*
Subnet Mask ###.###.###.###
(000.000.000.000)*
Gateway ###.###.###.###
(000.000.000.000)*
Node Name BRNXXXXXXXXXXXX
Auto* / Static
WINS Config
(Primary)
WINS Server
000.000.000.000
(Secondary)
000.000.000.000
(Primary)
DNS Server
000.000.000.000
(Secondary)
000.000.000.000
0 / 1 / 2 / 3* / ... / 32767
IP Boot Tries
On* / Off
APIPA
On / Off*
IPv6
- Auto* / 100B-FD / 100B-HD /
10B-FD / 10B-HD
Active 1000B-FD /
Active 100B-FD /
Active 100B-HD /
Active 10B-FD /
Active 10B-HD /
Inactive / Wired OFF
-
On* / Off
Descriptions
Chooses the IP method that
best suits your needs.
Enter the IP address.
1
Enter the Subnet mask.
1
Enter the Gateway address.
1
Enter the Node name.
Chooses the WINS
configuration mode.
Specifies the IP address of the
primary or secondary WINS
server.
Specifies the IP address of the
primary or secondary DNS
server.
Specifies the number of
attempts the machine will try to
obtain an IP address when the
Boot Method is set to any
setting except Static.
Automatically allocates the IP
address from the link-local
1
address range.
Sets use of IPv6 protocol.
Chooses Ethernet link mode.
Shows the Ethernet link status.
Shows MAC address of the
machine.
Chooses Ethernet link mode.
3
84