Only For Training And Service Purposes - LG U370 Service Manual

3.7.10 Stereo Wideband CODEC
The MSM6245 device integrates a wideband voice/audio CODEC into the mobile station modem
(MSM). The CODEC supports two differential microphone inputs, one differential earphone output, one
single-ended earphone output, and a differential analog auxiliary interface. The CODEC integrates the
microphone and earphone amplifiers into the MSM6245 device, reducing the external component
count to just a few passive components. The microphone (Tx) audio path consists of a two-stage
amplifier with the gain of the second stage set externally. The Rx/Tx paths are designed to meet the
ITU-G.712 requirements for digital transmission systems.
3.7.11 Vocoder Subsystem
The MSM6245 device's QDSP4000 supports AMR,FR,EFR and HR. In addition, the QDSP4000 has
modules to support DTMF tone generation, DTMF tone detection, Tx/Rx volume controls, Tx/Rx
automatic gain control (AGC), Rx Automatic Volume Control (AVC), ear seal echo canceller (ESEC),
Acoustic Echo Canceller (AEC), Noise Suppression (NS), and programmable, 13-tap, Type-I, FIR,
Tx/Rx compensation filters. The MSM6245 device's integrated ARM9TDMI processor downloads the
firmware into the QDSP4000 and configures QDSP4000 to support the desired functionality.
3.7.12 ARM Microprocessor subsystem
The MSM6245 device uses an embedded ARM926EJ-S microprocessor. This microprocessor,
through the system software, controls most of the functionality for the MSM device, including control of
the external peripherals such as the keypad, LCD, RAM, ROM, and EEPROM devices. Through a
generic single serial bus interface (SSBI) the ARM926EJ-S configures and controls the functionality of
the RFR6275, RTR6275, and PM6650 devices.
3.7.13 Mode Select and JTAG Interfaces
The mode pins to the MSM6245 device determine the overall operating mode of the ASIC. The options
under the control of the mode inputs are Native mode, which is the normal subscriber unit operation,
ETM mode, which enables the built-in trace mode, and test mode for factory testing. The MSM6245
device meets the intent of the ANSI/IEEE 1149.1A-1993 feature list. The JTAG interface can be used
to test digital interconnects between devices within the mobile station during manufacture.
Copyright © 2007 LG Electronics. Inc. All right reserved.

Only for training and service purposes

3. TECHNICAL BRIEF
- 43 -
LGE Internal Use Only