Hardware Overview; Leds And Buttons - D-Link DSP-W215 User Manual

Section 1 - Product Overview
1 WPS/Reset Button
2 Power Plug
3 Power Button
4 System Status LED
5 Power Socket
6 Power LED
D-Link DSP-W215 User Manual

Hardware Overview

LEDs and Buttons

1
2
Press for one second to start the WPS connection process. The System Status LED will start to blink green. To reset the
device to factory defaults, press and hold for about 10 seconds until the Status LED turns red.
Plug the Smart Plug into a wall power socket.
Press to turn the connected device on or off.
Solid Green
Blinking Green
Blinking Orange
Solid Red
Light Off
Connect your appliances, lamps, and other electronic devices you wish to monitor.
The LED will be solid green if the power socket is powered on.
3
6
The uplink is established and an IP is provisioned.
WPS is activated.
The uplink is not established or an IP is not provisioned.
The smart plug is powering on or is defective.
The smart plug is powered off.
4
5
4