Kenwood KDWTTB10 Installation Instructions Manual page 7

installation
7. Make sure your plumbing is suitable for
use with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS using
the new water inlet hose. OLD HOSE
SETS MUST NOT BE RE-USED. The
water pressure from the water mains
needs to be at a minimum of 0.04 MPa and
a maximum of 1.00MPa.
• Connect one end of the safety water
supply hose to your dishwasher, and
then connect the other end of the hose
to your water mains. Please ensure the
black rubber seal is in place.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
You may use a Y-adaptor (not included)
for an additional water feed for another
appliance, for example a washing
machine. This is only applicable for
cold water mains. A Y-adaptor is
available from most DIY stores.
• Do not bend your drain hose.
• Do not lift the drain hose higher than
10 cm from the table top, otherwise the
unit may not be able to expel the waste
water properly.
water mains
Y-Adaptor
(not included)
Connect to
another
appliance
if required.
water supply hose
max.
10cm
7