Switching Off The Unit; Unloading The Dishwasher; Delay Start; Key Lock - Kenwood KDWTTB10 Installation Instructions Manual

switching off the unit

To save energy, remember to switch the dishwasher off using the ON/OFF button. The dishwasher
will continue to use electricity until it is switched off with the ON/OFF button.
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday, disconnect
the unit from the mains supply.

unloading the dishwasher

Allowing dishes to cool down before unloading is important as dishes tend to break and chip more
easily when they are hot. Therefore, if you open the dishwasher door fully after switching off, it will
allow the dishes to cool down much faster.

delay start

The starting time of a washing programme can be delayed and adjusted. Please follow the steps
below.
1. Open the dishwasher door and load your soiled dishes and crockery. Close the door.
2. Press the ON/OFF button to turn on the dishwasher.
3. Select your preferred programme.
4. Press the "delay start" button.
5. Set the required delay start time using the "delay start" button.
Each press of this button increases the delay start time by 1 hour increments.
6. Close the door and the unit will start the programme at the assigned time automatically.

key lock

The key lock prevents children stopping the programme accidentally. It locks the control buttons.
Press the key lock button for 3 seconds to activate by lock function. Press it again for 3 seconds to
release the key lock function.
21