Reduce Temp; Water Plus Level; Maximum Rinse Level; Suds Cooling - Miele WMV 960 WPS Operating Instructions Manual

Table of Contents

Advertisement

Reduce temp.

The boiling point for water is lower at
altitudes of more than 1000 m above
sea level. In order to avoid water
boiling, the maximum temperature is
reduced to 80°C even when a higher
temperature is selected.
Factory default setting: the reduce
temperature setting is switched off.

Water plus level

There are four different water levels
which can be selected with Water
plus.
Level:
– Normal (Factory default setting)
– Plus 
– Plus 
– Plus 

Maximum rinse level

The water level in the rinse cycle can
be permanently set to the highest
value.
This function is useful for allergy
sufferers as it achieves an excellent
rinse result. Water consumption will
increase.
Factory default setting: the maximum
rinse level setting is switched off.

Suds cooling

When this is activated, additional
water flows into the drum at the end of
the main wash to cool the suds down.
Hot suds can damage plastic drainage
pipes.
Suds cooling takes place when a
Cottons programme with a temperature
of 70°C or higher is selected.
Suds cooling should be activated:
– to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where the drainage pipes do not
comply with DIN 1986.
Factory default setting: Suds cooling is
switched off.

Anti-crease

The Anti-crease function helps prevent
creasing if laundry is not going to be
removed immediately after the end of
the programme.
The drum continues to turn at intervals
for up to 30 minutes at the end of the
programme. The door can be opened at
any time.
Factory default setting: Anti-crease is
switched off.
Settings
109

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents