Panasonic KX-TDA50 Feature Manual page 34

1.3 C
[Programming Example: System Speed Dialing Table]
Location
(System Speed
Dialing No.)
000
001
→ 2.12.1 [6-1] System Speed Dial—CO Line Access Number + Telephone Number
*1
→ [001] System Speed Dialing Number
→ 2.12.1 [6-1] System Speed Dial—Name
*2
→ [002] System Speed Dialing Name
→ 2.12.1 [6-1] System Speed Dial—CLI Destination
*3
5.
Displaying the Caller's Name
In addition to the System Speed Dialing Table, each extension can store names and numbers in
Personal Speed Dialing. Therefore, it is entirely possible for the same telephone number to be stored
under a different name in different locations within the PBX.
When a call containing Caller ID information is received, the PBX will search for the caller's name in the
following order, then show that name on the display and log it via SMDR.
1)
Personal Speed Dialing data of the extension which received the call
2)
System Speed Dialing Table
3)
The Caller ID information received from the telephone company
If a caller's name is not stored in the PBX or sent from the telephone company, it will not be displayed
or logged.
Conditions
[General]
• Caller ID signaling type can be selected through system programming.
[Caller ID to SLT Port]
• Hardware Requirement:
KX-TDA50: The EXT-CID card
KX-TDA100/KX-TDA200/KX-TDA600: The EXT-CID card on the SLC-8 card
• When the caller's number is sent to an SLT, a CO Line Access number can be automatically added to
the telephone number through system programming for calling back.
• KX-TDA50 only
Through system programming, a group of 4 SLT or Super Hybrid ports can be assigned to receive
Caller ID information. Up to 2 groups can be programmed. Therefore, a maximum of 8 SLTs can receive
Caller ID information.
Note that SLTs connected in parallel to DPTs attached to Super Hybrid ports can only receive Caller ID
information when set to "ring" mode.
• When the caller's number exceeds 16 digits, the SLT receives only the first 16 digits, not counting the
preceding CO Line Access number (if it is programmed to be added).
• If a call is transferred to an SLT, the transferring extension's information will be shown on the SLT. If the
transferring extension goes on-hook before the call is answered, the original caller's information will be
shown.
34 Feature Manual
System Speed
Telephone No.
Dialing Name
*1
ABC Company 912125551234
XYZ Company 913135551234
CLI Destination
*2 *3
200
300