1
1. Rotation with hammering
2. Lock button
3. Pointer
4. Change lever
1
1. Rotation only
2. Pointer
2
1. Hammering only
2. Pointer
Selecting the action mode
Rotation with hammering
003128
For drilling in concrete, masonry, etc., depress the lock button and rotate the
2
change lever so that the pointer points to the
bide tipped bit.
3
4
Rotation only
003131
For drilling in wood, metal or plastic materials, depress the lock button and
rotate the change lever so that the pointer points to the
drill bit or wood bit.
2
Hammering only
003133
1
For chipping, scaling or demolition operations, depress the lock button and
rotate the change lever so that the pointer points to the
point, cold chisel, scaling chisel, etc.
CAUTION:
•
Do not rotate the change lever when the tool is running. The tool will be
damaged.
•
To avoid rapid wear on the mode change mechanism, be sure that the
change lever is always positively located in one of the three action mode
positions.
Torque limiter
The torque limiter will actuate when a certain torque level is reached. The
motor will disengage from the output shaft. When this happens, the bit will stop
turning.
CAUTION:
•
As soon as the torque limiter actuates, switch off the tool immediately.
This will help prevent premature wear of the tool.
symbol. Use a tungsten-car-
symbol. Use a twist
symbol. Use a bull
7