[Auto] - Panasonic DMW-FL360 Operating Instructions Manual

:>ress the [MODE] button, and
5elect the flash mode. (P28)
1 Press the [ZOOM] button
to set the zoom value to
the focal length of the
lens.
• If the combination of the ISO
sensitivity and aperture are
outside the usable range, a
warning is given in the form of
the flashing ISO sensitivity and
aperture displays. In a case like
this, change the ISO sensitivity
and aperture.
4 Press the shutter button
all the way down, and
take the photo.
S Check that the [AUTO
CHECK] lamp is flashing.
29
VQT1810
AUTO CHECK
~A-.(
. . .
O~
p.,..
• If the [AUTO CHECK] lamp
continues to flash for about
5 seconds, it means that the unit
has fired successfully. If it does
not flash, the unit has not fired
successfully. Check the settings
on the unit and the digital
camera and then take the
picture again.
I
[lC-:E0Y ,
::::::.>::-:.:-:-:-:::.:-::::::::::::::::::::::-::>:.:-::::::::::::::::::::::::::::::::.:-:.>::-:.:.:-:-::::::::::::::::::::::::::::::.:.:-:::-:::::-:::::::::::::::::::::::-:::.:-::-:::
• The flash intensity can be
adjusted in 1/3 steps by varying
the ISO sensitivity and aperture
from the digital camera settings.
I ;r~.~l :j~:r
., L:f
.tJ
:l~.:C#
.......",. o;,..:,.:..:.:
~
...,..;...;..;..;-.;.;:...:..:.:.:•••'
~ ~.;...:..::.:.: ~......,..,..,
;"',.,;.,;.o;,..:,.;.:..:..:.:•••••••..;
2 Press and hold the
[MODE] button and then
turn the select dial within
2 seconds to set the ISO
sensitivity.
• The unit will switch to the
function settings if the [MODE]
button is pressed for more than
2 seconds. (P39)
3 Turn the select dial and
set it to the aperture of
the lens.