Black & Decker ks710l Manual page 5

g. Use the power tool, accessories and tool bits etc.,
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed. Use of the power tool
for operations different from those intended could result
in a hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
Additional safety instructions for jigsaws
Warning! Contact with or inhalation of dusts arising
N
from cutting applications may endanger the health of the
operator and possible bystanders. Wear a dust mask
specifically designed for protection against dust and
fumes and ensure that persons within or entering the
work area are also protected.
Additional safety instructions for lasers
Warning! Laser radiation.
Do not look into the laser beam.
Do not view the laser beam directly with optical
instruments.
Refer to the laser product characteristics.
This laser complies with class 2 according to EN 60825-
N
1:1 1994+A11. Do not replace a laser diode with a different
type. If damaged, have the laser repaired by an authorised
repair agent.
Do not use the laser for any purpose other than projecting
N
laser lines.
An exposure of the eye to the beam of a class 2 laser is
N
considered safe for a maximum of 0.25 seconds.
Eyelid reflexes will normally provide adequate protection.
At distances over 1 m, the laser complies with class 1 and
thus is considered completely safe.
Never look into the laser beam directly and intentionally.
N
Do not use optical tools to view the laser beam.
N
Do not set up the tool at a position where the laser beam
N
can cross any person at head height.
Do not let children come near the laser.
N
Warning! This tool is intended for indoor use only.
Do not use the tool for outdoor applications.
Overview
This tool includes some or all of the following features.
1. On/off switch
2. Lock-on button
3. Variable speed control knob
4. Laser on/off switch
5. Laser aperture
6. Dust shroud
7. Blade support roller
8. Shoe plate
9. Pendulum stroke selector
10. Dust extraction adaptor
11. Allen key
Assembly
Warning! Before attempting any of the following operations,
make sure that the tool is switched off and unplugged and
that the saw blade has stopped.
Fitting the saw blade (fig. A)
Remove the dust shroud (6).
N
Loosen the screw (12) using the Allen key (11) provided.
N
Hold the saw blade (13) as shown, with the teeth facing
N
forward.
Insert the shank of the saw blade into the blade holder
N
(14) as far as it will go.
Tighten the screw (12).
N
Fitting and removing the parallel fence (fig. B)
The parallel fence is used to saw in a straight line parellel to
the edge of the workpiece. The fence can be fitted both to the
left side and to the right side.
Fitting
Loosen the locking knob (15).
N
Insert the parallel fence (16) through the openings (17).
N
Slide the parallel fence into the desired position.
N
Tighten the locking knob.
N
Removing
Loosen the locking knob (15).
N
Pull the parallel fence off the tool.
N
ENGLISH
5