Display Assembly; Removing The Display Assembly - Dell Inspiron 1370 Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ 1370 Service Manual
Display Assembly
Display Hinge Covers
Display Bezel
Display Hinges
Display Panel
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Display Assembly

Removing the Display Assembly

1. Follow the procedures in Before You
2. Remove the battery (see Removing the
3. Follow the instructions from
4. Remove the SIM board (see
5. Make a note of the Mini-Card antenna cable routing and carefully dislodge the antenna cables from the routing guides on the computer base. Pull the
cables away so that they are clear of the computer base.
6. Remove the four screws that secure the display assembly to the computer base.
7. Slide the hinges out of the slots in the computer base.
8. Lift the display assembly off the computer base.
1

display assembly

3 Mini-Card antenna cables
Begin.
Battery).
step 3 to step 15 in Removing the System
Removing the SIM Board).
2 screws (4)
4 display hinges (2)
Removing the
Board.
Battery) before working inside the