Specifications - Makita RP0900 Instruction Manual

ENGLISH (Original instructions)
1-1. Stopper pole
1-2. Screw
2-1. Lock lever
2-2. Screw
3-1. Depth pointer
3-2. Screw
3-3. Stopper pole
3-4. Adjusting hex bolt
3-5. Stopper block
4-1. Depth pointer
4-2. Screw
4-3. Stopper pole

SPECIFICATIONS

Collet chuck capacity
Plunge capacity
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : cuttig grooves in MDF
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
4-4. Adjusting hex bolt
4-5. Stopper block
5-1. Lock lever
5-2. Screw
6-1. Switch trigger
8-1. Feed direction
8-2. Bit revolving direction
8-3. Workpiece
8-4. Straight guide
10-1. Guide bar
10-2. Clamp screw
10-3. Straight guide
Model
-1
)
Overall height
Net weight
Safety class
) : 89 dB(A)
pA
) : 100 dB(A)
WA
value (tri-axial vector
2
) : 4.0 m/s
h
2
ENE010-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENF002-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENG102-3
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG223-2
For European countries only
sum)
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Router
Model No./ Type: RP0900
4
13-1. Screw
13-2. Base
13-3. Template guide
14-1. Bit
14-2. Base
14-3. Templet
14-4. Workpiece
14-5. Distance (X)
14-6. Outside diameter of the templet
guide
14-7. Templet guide
RP0900
6mm, 1/4", 8 mm and/or 3/8"
0 - 35 mm
27,000
217 mm
2.7 kg
/II
Corporation as
ENG901-1
ENH101-13
the responsible