Brother PDS-5000 Quick Setup Manual page 13

Product Safety Guide
IMPORTANT
• DO NOT put objects on top of the unit.
• If the machine does not operate normally when
the operating instructions are followed, adjust
only those controls that are covered by the
operating instructions. Improper adjustment of
other controls may result in damage or minor
exposure to electromagnetic waves and will
often require extensive work by a qualified
technician to restore the machine to normal
operation.
• A distinct change in the machine's performance
may indicate a need for service.
Important safety instructions
DO NOT attempt to service the unit yourself because
opening or removing covers may expose you to
dangerous voltage points and other risks and may
void your warranty. Refer all servicing to a Brother
Authorized Service Center. For the location of your
nearest Brother Authorized Service Center, please
call:
In USA: 1-877-BROTHER (1-877-276-8437)
In Canada: www.brother.ca/support
Regulation
Federal Communications
Commission (FCC)
Declaration of Conformity
(USA only)
Responsible Party: Brother International Corporation
200 Crossing Boulevard
Bridgewater, NJ 08807-0911 USA
TEL: (908) 704-1700
declares, that the products
Product Name: PDS-5000 and PDS-6000
comply with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment
and receiver.
 Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV
technician for help.
IMPORTANT
• Changes or modifications not expressly
approved by Brother Industries, Ltd. could void
the user's authority to operate the equipment.
• A specific shielded interface cable should be
used to ensure compliance with the limits for
a Class B digital device.
13