Mitsubishi Electric F700 Instruction Manual page 178

Selection of operation mode and
operation location
(5) Selection of control source in network operation mode (Pr. 338, Pr. 339)
⋅ As control sources, there are the operation command sources that control the signals related to the inverter start
command and function selection and the speed command source that controls the signals related to frequency setting.
⋅ In network operation mode, the commands from the external terminals and communication (RS-485 terminals or
communication option) are as listed below.
Operation Pr. 338 Communication operation command source
Location
Pr. 339 Communication speed command source 0: NET
Selection
Running frequency from communication
Fixed function
Terminal 2
(Terminal-
equivalent
Terminal 4
function)
Terminal 1
Low speed operation command/
0 RL
remote setting clear
Middle-speed operation command/
1 RM
remote setting deceleration
High speed operation command/
2 RH
remote setting acceleration
3 RT Second function selection
4 AU Terminal 4 input selection
5 JOG Jog operation selection
Selection of automatic restart after
6 CS
instantaneous power failure
7 OH External thermal relay input
8 REX Fifteen speed selection
10 X10 Inverter operation enable signal
FR-HC or MT-HC connection,
11 X11
instantaneous power failure detection
12 X12 PU operation external interlock
14 X14 PID control valid terminal
16 X16 PU-external operation switchover
Output stop
24 MRS
PU operation interlock
25 STOP Start self-holding selection
60 STF Forward rotation command
61 STR Reverse rotation command
62 RES Reset
63 PTC PID forward action switchover
64 X64 PID forward action switchover
65 X65 PU-NET operation switchover
66 X66 External-NET operation switchover
67 X67 Command source switchover
[Explanation of table]
External : Operation is valid only from external terminal signal.
NET : Control only from communication is valid
Combined : Operation is valid from either of external terminal and communication.

: Operation is invalid from either of external terminal and communication.
Compensation : Control by signal from external terminal is only valid when Pr. 28 Multi-speed input compensation selection = "1"
REMARKS
⋅ The control source of communication is as set in Pr. 550 and Pr. 551.
170
0: NET
1:External 2:External 0: NET

NET NET NET
 
External

External
Compensation
NET External NET
NET External NET
NET External NET
NET

Combined

External
External
NET External NET
External
External
External
NET External NET
External
Combined
External

NET
NET
External
External
NET External NET
External
External
External
1: External
1:External 2:External

NET
 
External

External
External
Pr. 59 = "0" (multi-
External
Pr. 59 = "1 , 2"
External
External

Combined
External
External
(multi-speeds)
External
External
Pr. 79
When X12 signal
is not assigned
External
External
External
External
Remarks
speeds)
(remote)
Pr. 59 = "0"
≠
"7"
Pr. 79 = "7"