AEG SR 4352 Instruction Manual page 31

Overview of the Components
1 Handle
2 Telescopic antenna
3 CD compartment
4 Band selector switch (FM ST / AM)
5 Radio scale
6 TUNING control
7 PUSH OPEN CD tray (open/close)
8 / button (Play/Pause / deactivate standby)
9 NEXT button (forward search)
10 FOLD+/+10 button (Skip track/ album up)
11 LCD display
12 PROG/P-MODE button (Memory/Repeat/random play-
back)
13 FM ST. control lamp
14 FOLD-/-10 button (Skip track/ album down)
15 BACK button (reverse search)
16 STOP button
17 POWER control lamp
18 VOLUME (volume control)
19 FUNCTION Function selector switch (RADIO / OFF /
CD/MP3/AUX)
Reverse (not shown)
AC Mains connection
AUX IN jack (3.5 mm jack plug)
Underside (not shown)
Battery compartment
Intended Use
This device is used for:
• The reception of radio programmers
• Playing back audio/MP3 CDs
• Audio reproduction of external audio sources.
It is intended exclusively for this purpose and may only be
used as such.
It may only be used in the manner described in these instruc-
tions for use. The device must not be used for commercial
purposes.
Any other use of this device is considered to be contrary to
the intended use and may result in damage to materials or
even personal injury.
The firm ETV – Elektro-Technische Vertriebsgesellschaft mbH
does not accept any liability for damage caused as a result of
the use of this device contrary to its intended use.
Start-up of the device/introduction
• Please read the operating instructions carefully before
using the device for the first time!
• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
• Remove the protective film from the display if it is still
present.
Power Supply
• Connect the power cable supplied (see battery compart-
ment if necessary) to a properly installed safety power
socket and the mains connector AC on the back of the
machine.
• Ensure that the voltage is the same as that indicated on
the model identification plate.
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment on the bottom.
• Insert 6 batteries of type C/R14 1.5 V. Please ensure that
the polarity is correct (see the floor of the battery com-
partment)!
• If the device is not used for a long period of time, remove
the batteries to avoid the spilling of battery acid.
• Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are auto-
matically switched off.
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
WARNING:
Do not expose the batteries to intense heat, such as sun-
light, fire or similar. Danger of explosion!
Transport Safety Device, CD Compartment
• Open the CD tray (3) by pressing the PUSH OPEN button
(7).
• Before operating the machine for the first time, remove
the transport safety device from the CD player if it is still
in place.
Volume
The desired volume can be sent using the VOLUME regula-
tor (18).
Switch-off
The machine is switched off when the function selector switch
(19) is turned to the OFF position. The POWER (17) control
lamp goes off. Unplug the device.
English
31