Table of Contents
Advertisement
ENGLISH
Use
Switching on and off (Fig. A)
Press the button to turn, on the unit operates in slow
u
speed, low power mode, conserving the battery life.
Press the button again, and the unit goes to a BOOST
u
mode.
Pressing the button again will turn the product off.
u
Using the pull out crevice tool (Fig. B,C)
Extend the crevice tool (4) as shown in figure C, until it
u
clicks in place. The push in brush (7) can then be fitted if
required for dusting and upholstery cleaning.
To retract the crevice tool (4) press the crevice tool release
u
button (4a) allowing it to return to its normal position
(Fig. B).
Fitting the floor extension tube (Fig. D)
Slide the nozzle (3) into the floor extension tube (9) until
u
you hear an audible 'click' as shown in figure D.
The floor extension tube is supplied with a flip down brush
u
(11) for cleaning difficult to reach areas (Fig.E).
Fitting the floor head (Fig. F)
Slide the floor extension tube (9) onto the floor extension
u
head (12) until you hear an audible 'click' as shown in
figure F.
Floor sense feature
The appliance is fitted with a unique floor sensing feature.
It senses thick pile carpet and automatically goes from low
speed to BOOST mode for greater cleaning performance.
Removing and clearing hair from the beater
bars
(Fig. G, H)
Depress the beater bar unit (16) release button (17) as
u
shown in figure G.
The beater bar (18) can now be removed. The end pieces
u
are also removable allowing you to clear any hair or other
debris that may have accumulated during use (Fig. H).
Charging (Fig. I)
The appliance can be charged either as a single unit or while
attached to the floor extension.
Wall Mounting
The wall mount (13) can be attached to a wall to provide a
convenient storage for the appliance.
Warning! When fixing to a wall, make sure that the fixing
method is suitable for the wall type and is appropriate to the
weight of the appliance.
8
(Original instructions)
Mark the location of the screw holes (within reach of an
u
electrical outlet for charging the vac while it is on the wall
bracket).
Place the charger (14) into the charging port (15) and plug
u
into the electrical outlet.
Switch the electrical outlet on. The LED charging indicator
u
(B) will Illuminate.
Multi LED Display
A
B
C
A. Filter sensor
Whenever a filter is blocked and needs cleaning, the red
filter LED (A) in the handle will illuminate.
Clean fine dust from filter (See section on 'cleaning filters'
in this manual).
B. LED Charging display
Battery icon will illuminate when appliance requires
charging. LED display indicates state of charge (See LED
pattern chart in this manual).
C. BOOST mode
Illuminates when the appliance is in BOOST mode
allowing you to operate at higher power.
Hide quick links:
Advertisement
Table of Contents
