Mitsubishi Electric F700 Instruction Manual page 83

Parameter list
Parameter
PU display
145
language selection
148,149
Refer to Pr.22 and Pr.23.
—
Output current
150
detection level
Output current
151
detection signal
delay time
Zero current
152
detection level
Zero current
153
detection time
Output current
detection signal
166
retention time
Output current
detection operation
167
selection
154
Refer to Pr.22 and Pr.23.
—
RT signal function
155
validity condition
selection
156, 157
Refer to Pr.22 and Pr.23.
158
Refer to Pr.54 to Pr.56.
—
159
Refer to Pr.135 to Pr.139.
User group read
160
selection
User group
registered display/
172
batch clear
User group
173
registration
User group clear
174
78
Incre Initial
Name
ments Value
1 1
0.1% 110%
0.1s 0s
0.1% 5%
0.01s 0.5s
0.1s 0.1s
1 0
1 0
1 9999
1 0
1 9999
1 9999
Range Description
0 Japanese
1 English
2 Germany
3 French
4 Spanish
5 Italian
6 Swedish
7 Finnish
Set the output current detection level.
0 to 120%
100% is the rated inverter current.
Set the output current detection period.
Set the time from when the output current
0 to 10s
has risen above the setting until the output
current detection signal (Y12) is output.
Set the zero current detection level.
0 to 150% Suppose that the rated inverter current is
100%.
Set this parameter to define the period
from when the output current drops below
0 to 1s
the Pr.152 value until the zero current
detection signal (Y13) is output.
Set the retention time when the Y12
0 to 10s
signal is on.
The Y12 signal on status is retained.
9999
The signal is turned off at the next start.
Operation continues when the Y12 signal
0
is on
The inverter is brought to an alarm stop
1
when the Y12 signal is on. (E.CDO)
Second function is immediately made
0
valid with on of the RT signal.
Second function is valid only during the
RT signal is on and constant speed
10
operation.
(Invalid during acceleration/deceleration)
Only the simple mode parameters can be
9999
displayed.
Only the parameters registered in the user
1
group can be displayed.
Simple mode and extended mode
0
parameters can be displayed.
Displays the number of cases registered as
(0 to 16)
a user group (reading only).
9999 Batch clear the user group registration
Set the parameter numbers to be
0 to 999,
registered to the user group.
9999
Read value is always "9999".
Set the parameter numbers to be cleared
0 to 999,
from the user group.
9999
Read value is always "9999".
All
Param Param
param
eter eter
eter
copy clear
clear
: enabled
× : disabled
× ×
× ×
× ×
× ×