Emc Filter - Mitsubishi Electric F700 Instruction Manual

Wiring
2.4.2

EMC filter

This inverter is equipped with a built-in EMC filter (capacitive filter) and common mode core.
The EMC filter is effective for reduction of air-propagated noise on the input side of the inverter.
The EMC filter is factory-set to enable (ON). To disable it, fit the EMC filter ON/OFF connector to the OFF position.
The input side common mode core, built-in the FR-F740-01160 or less inverter, is always valid regardless of on/off of
the EMC filter on/off connector.
00023 to 00126
EMC filter OFF EMC filter ON
(initial setting)
00023 to 00126
00170, 00250
<How to disconnect the connector>
(1) Before removing a front cover, check to make sure that the indication of the inverter operation panel is off, wait for
at least 10 minutes after the power supply has been switched off, and check that there are no residual voltage
using a tester or the like. (For the front cover removal method, refer to page 4.)
(2) When disconnecting the connector, push the fixing tab and pull the connector straight without pulling the cable or
forcibly pulling the connector with the tab fixed. When installing the connector, also engage the fixing tab securely.
If it is difficult to disconnect the connector, use a pair of long-nose pliers, etc.
EMC filter
ON/OFF connector
(Side view)
CAUTION
⋅ Fit the connector to either ON or OFF.
While power is on or when the inverter is running, do not open the front cover. Otherwise you may get an electric shock.
8
00170, 00250
EMC filter OFF EMC filter ON
(initial setting)
00310, 00380
Disengage connector fixing tab
WARNING
EMC filter OFF
00770 or more
00470, 00620
With tab disengaged,
pull up connector straight.
00310 or more
EMC filter ON
(initial setting)
EMC filter
ON/OFF
connector
U V W