Attaching A Viewfinder - Sony F35 Operation Manual

1
Loosen the fixing screw using a screwdriver, then open
the cover.
2
Rotate the adjustment screw using an Allen wrench.
Clockwise rotation lengthens the flange focal length,
and counterclockwise rotation shortens it.
Remember as a guide that ±3 turns of the screw
correspond to variation of the flange focal length of
±0.15 mm.
When the adjustment is finished, close the cover and
tighten the fixing screw.
24

Attaching a Viewfinder

2-5 Attaching a
Viewfinder
Caution
When the viewfinder is attached, do not leave the camera
with the eyepiece facing the sun. Direct sunlight can enter
through the eyepiece, be focused in the viewfinder and
cause fire.
For details on the viewfinder, refer to the instruction
manual of the viewfinder.
If the viewfinder must be attached lower
Loosen the two screws, using the 2.5-mm wrench stored in
the wrench box (page 16) to detach the viewfinder shoe,
and attach it to the lower position using the lower screw
holes.
Attaching procedure
1
Fit the viewfinder to the viewfinder shoe and slide the
viewfinder horizontally.
The viewfinder stopper automatically pops down.
Stopper
2
Set the viewfinder to the most convenient position,
tighten the viewfinder positioning ring (1 in the
figure below), and connect the viewfinder cable to the
VF1 connector of the camera (2 in the figure below).