Sony F35 Operation Manual page 112

Code
0005 NO PB VITC
0007 REC INHIBIT MODE
0008 INVALID FMT CONV
0009 TEMPERATURE LOW
000C DC VOLTAGE LOW
000E TEMPERATURE HIGH
000F VA MISSING
0010 TELEFILE FULL
0011 TELEFILE NO ROOM
0013 TELEFILE FMT NG
0014 TELEFILE RD FAIL
0015 TELEFILE WR FAIL
0016 TELEFILE WR INHI
0017 NO TELEFILE LABE
0022 AUDIO PLL UNLOCK
0030 NO SDI INPUT
0032 INVALID SDI DATA
0034 SDI A-B PHASE NG
0036 SDI FMT MISMATCH
0037 SDI I/P MISMATCH
004F AUDIO DSP UNLOCK
0050 NO PB RF
0051 BAD CH CONDITION
0060 LOST LOCK
0067 CASSETTE REC INHI
4. Audio Delay
To synchronize an audio signal externally recorded
together with video signal output from the camera,
appropriate delay shown in the table below is required for
phase alignment between video and audio.
IMAGE INVERT
OFF
Number Code
of frames (HEX)
2 20
3 30
2 20
3 30
2 20
112
About Metadata
Sample No. 52 and 53 VTR Warning
VTR message
Sample No. 61 Audio Delay
ON
Number Code
of frames (HEX)
3 30 1080/23.98PsF
3 40 1080/S23.98PsF
3 30 1080/24PsF
3 40 1080/S24PsF
3 30 1080/25PsF
Meaning
Playback VITC cannot be detected.
The system cannot record because of a record inhibit menu
setting. Or the tape is not formatted for recording.
Format conversion is not possible with the current settings.
The temperature inside the unit is lower than the specified value.
DC voltage has fallen below the specified level.
The temperature inside the unit has risen.
SRPC-1 is not connected.
Telefile memory is almost full. The next recording will erase
existing data, beginning with oldest.
Free memory in a Telefile has been completely exhausted.
Telefile format is invalid in 1 or more locations.
Telefile read failure occurred.
Telefile write failure occurred.
Attempt to record was made when entire Telefile is write inhibited.
Telefile could not be recognized.
Audio clock generator PLL is not locked to reference video signal.
When the optional HKSR-101 is installed, there is no valid input to
the selected VIDEO I/O connector.
SDI input signal data are invalid.
Signals input to HD SDI IN A and B connectors are out of phase.
Format of signals input to HD SDI IN A and B connectors does not
match system setting.
I/P of signals input to HD SDI IN A and B connectors do not match
system setting.
Audio signal processing circuitry is not operating.
Playback head is not reading digital data from tape.
Playback signal quality is bad.
Capstan servo lock was lost during playback or recording.
The cassette is record-protected.
The values shown in the Code column are recorded as
Metadata.
Video format
4:4:4 1080/23.98PsF
4:4:4 1080/S23.98PsF
4:4:4 1080/24PsF
4:4:4 1080/S24PsF
4:4:4 1080/25PsF
4:2:2
4:2:2
4:2:2
4:2:2
4:2:2