Nokia Wireless Headset (HS-26W) User Guide...
Nokia operates a policy of continuous development. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice. Under no circumstances shall Nokia be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.
Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with the Nokia dealer nearest to you. Unauthorized changes or modifications to this device may void the user's authority to operate the equipment.
Mute or unmute the microphone ... 12 Switch the call between phone and headset ... 12 Use the headset with several phones ... 12 Clear the settings ... 13 4. Battery information... 14 Care and maintenance ... 15 Copyright © 2005 Nokia. All rights reserved.
1. Introduction You can connect the Nokia Wireless Headset (HS-26W) to a compatible phone that supports Bluetooth wireless technology. This allows you freedom to make and receive calls while on the move or in the office. Read this user guide carefully before using the headset. Read also the user guide for your phone, which provides important safety and maintenance information.
• Volume key (4) increases or decreases the earphone volume during a call. To mute or unmute the ongoing call, press the middle part of the volume key briefly. • Microphone (5) picks up your voice. Copyright © 2005 Nokia. All rights reserved.
■ Chargers and batteries Check the model number of any charger before using it with this device. The Nokia Wireless Headset (HS-26W) is intended for use with the AC-3, AC-4, and DC-4 chargers.
To switch off, press and hold the power key for 2 seconds. The headset beeps, and the red indicator light is displayed briefly. ■ Pair the headset with a compatible phone 1. Switch on your phone and the headset. Copyright © 2005 Nokia. All rights reserved.
2. Activate the Bluetooth feature on the phone, and set the phone to search for Bluetooth devices. See the user guide of your phone for instructions. 3. Select the headset (Nokia HS-26W) from the list of found devices. 4. Enter the passcode 0000 to pair and connect the headset to your phone. In some phones you may need to make the connection separately after pairing.
You can set your phone to connect with the headset automatically when the headset is switched on. To do this in Nokia phones, change your paired device settings in the Bluetooth menu. ■ Troubleshooting If you cannot connect the headset to your phone, do as follows: •...
If your phone supports voice dialing, press and hold the answer/end key when no call is in progress, and proceed as described in the user guide of your phone. Copyright © 2005 Nokia. All rights reserved.
■ Switch the call between phone and headset To switch the call between the headset and a compatible Nokia phone, press and hold the answer/end key, or use the respective function in your phone. ■ Use the headset with several phones You can pair the headset with up to eight phones but connect it to only one phone at a time.
10 seconds. After the settings are cleared, the headset beeps twice, and the red and green indicator lights alternate for several seconds. Copyright © 2005 Nokia. All rights reserved.
Recharge your battery only with Nokia approved chargers designated for this device. Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime.
• Do not paint the device. Paint can clog the moving parts and prevent proper operation. All of the above suggestions apply equally to your device, battery, charger, or any enhancement. If any device is not working properly, take it to the nearest authorized service facility. Copyright © 2005 Nokia. All rights reserved.