Nokia Bluetooth Headset BH-902 User Guide 9203798 Issue 1 EN...
Under no circumstances shall Nokia be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.
Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with the Nokia dealer nearest to you.
C o n t e n t s Contents 1. Introduction ... 6 Bluetooth wireless technology... 7 2. Get started... 9 Overview ... 9 Chargers... 10 Charge the battery... 11 Switch on or off... 12 Pair the headset... 12 Disconnect the headset... 14 Reconnect the headset...
C o n t e n t s 4. Battery information ... 26 Care and maintenance ... 28...
I n t r o d u c t i o n Introduction With the Nokia Bluetooth Headset BH-902 you can make and receive calls while on the move and use your mobile device hands free. You can use the headset with compatible devices that support Bluetooth wireless technology.
I n t r o d u c t i o n ■ Bluetooth wireless technology Bluetooth wireless technology allows you to connect compatible devices without cables. A Bluetooth connection does not require that the mobile device and the headset be in line of sight, but the maximum distance between the devices is 10 meters...
I n t r o d u c t i o n (PBAP) 1.0. Check with the manufacturers of other devices to determine their compatibility with this device. There may be restrictions on using Bluetooth technology in some locations. Check with your local authorities or service provider.
Get started ■ Overview The headset contains the following parts: charger connector (1), volume down key (2), answer/end key (3), volume up key (4), earloop (5), display (6), earpiece (7), power key (8), and microphone (9). Before you can start using the headset, you must charge the battery and pair the headset with a compatible device.
The headset is intended for use with the AC-3, AC-4, AC-5, and DC-4 chargers. Warning: Use only chargers approved by Nokia for use with this particular enhancement. The use of any other types may invalidate any approval or warranty and may be dangerous.
■ Charge the battery The headset has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the headset, as you may damage the headset. 1. Connect the charger to a wall outlet. 2. Connect the charger cable to the charger connector on the headset.
■ Switch on or off To switch on, press and hold the power key until the headset beeps and the Nokia logo is displayed. If the headset has been paired with a device, it tries to connect to it. If the headset has not been paired with a device, it enters the pairing mode (see “Pair the headset,”...
3. Activate the Bluetooth feature on the mobile device, and set the device to search for Bluetooth devices. 4. Select the headset (Nokia BH-902) from the list of found devices on your device. 5. Enter the passcode 0000 to pair and connect the headset to your device.
Bluetooth menu of the device, or press and hold the answer/end key. In your device, you may be able to allow the headset to connect to it automatically when the headset is switched on. To do this in Nokia devices, change your paired device settings in the Bluetooth menu.
■ Display When the headset is on and it is not used for about 10 seconds, the display enters the power saving mode. In this mode the display turns off for about 5 seconds and turns on for about 1 second at regular intervals. To activate the display when it is in the power saving mode, briefly press the answer/end key or either volume key;...
The microphone is muted (during a call). There are unread text or multimedia messages in your mobile device. The icon is shown only when the headset is connected to a compatible Nokia device. The battery is fully charged. The battery charge is low.
B a s i c u s e Basic use ■ Place the headset over the ear The headset is provided with an earloop that you can use for a better fit on your ear. Peel off the protective sheet from the earpiece. To use the headset with the earloop, slide the earloop over your ear (1), and gently plug the earpiece into your ear.
B a s i c u s e To use the headset on the left ear, rotate the earloop so that the loop is to the left of the Nokia logo (3). To use the headset without the earloop, detach the earloop by gently pulling it from the small opening at the back of the headset, and plug the headset into your ear.
B a s i c u s e When you do not keep the headset on your ear, you can attach it to your clothing or belt using the clip or carry it on the strap around your neck. To fix the headset to the clip or strap, insert the headset into the catch (1), and gently push it downwards (2) until it locks into place (3).
B a s i c u s e If your device supports last number redialing with the headset, press the answer/end key twice while no call is in progress. If your device supports voice dialing with the headset, press and hold the answer/end key when no call is in progress, and proceed as described in the user guide for your device.
B a s i c u s e switch between the active call and the call on hold, press and hold the answer/end key. To end the active call and make the call on hold active, press the answer/end key. ■...
B a s i c u s e several times depending on the current menu level; or wait until the display turns off to save power. View recent calls To view recent calls, select Recent calls and the desired submenu. You can view the 10 most recent dialed, received, and missed calls.
To set the hours or minutes, press either volume key repeatedly (or press and hold the key), and press the answer/end key. The time is updated from the connected Nokia device if the device provides the time.
Language. Scroll to the desired language, and press the answer/end key twice. The language is updated from the connected Nokia device if the device provides the language setting. To set the display brightness, select Brightness. Scroll to the desired level, and press the answer/end key.
B a s i c u s e ■ Clear settings or reset To restore the original settings of the headset, use the Setup > Reset function described in “Menu functions,” p. 21. Alternatively, switch off the headset, press and hold the power key and answer/end key, and press the answer/ end key to confirm the operation.
Recharge your battery only with Nokia approved chargers designated for this device. Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime.
B a t t e r y i n f o r m a t i o n Do not dispose of batteries in a fire as they may explode. Batteries may also explode if damaged.
C a r e a n d m a i n t e n a n c e Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage.
• Do not attempt to open the device. • Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and fine mechanics. • Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. •...
Collection information is available from the product retailer, local waste authorities, national producer responsibility organizations, or your local Nokia representative. For more information, see product Eco-Declaration or country-specific information at...