Servicing Note - Sony D-EJ119 Service Manual

NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.
BEFORE REPLACING THE OPTICAL PICK-UP BLOCK
Please be sure to check thoroughly the parameters as par the "Optical
Pick-Up Block Checking Procedures" (Part No.: 9-960-027-11)
issued separately before replacing the optical pick-up block.
• FOK output: IC601 yg pin
When checking FOK, remove the lead wire to disc motor.
• RF signal P-to-P value: 0.45 to 0.65 Vp-p
LASER DIODE AND FOCUS SEARCH OPERATION
CHECK
During normal operation of the equipment, emission of the laser
diode is prohibited unless the upper lid is closed while turning ON
the S809. (push switch type)
The following checking method for the laser diode is operable.
• Method:
Emission of the laser diode is visually checked.
1. Open the upper lid.
2. With a disc not set, turn on the S809 with a screwdriver having a
thin tip as shown in Fig.1.
3. Press the u button.
4. Observing the objective lens, check that the laser diode emits
light.
When the laser diode does not emit light, automatic power control
circuit or optical pickup is faulty.
In this operation, the objective lens will move up and down 4
times along with inward motion for the focus search.
S809
Fig. 1 Method to push the S809
SECTION 1

SERVICING NOTE

lever(lid detection)
lever(lid detection)
MAIN board
D-EJ119/EJ120/EJ121
TEST MODE
The software version display and LCD test can be performed when
the test mode is activated.
Procedure:
1. Confirm the set is not powered on. (Remove two batteries and
disconnect the AC power adaptor.)
2. Short the solder land SL801 (TEST) on the MAIN board.
3. Turn on the main power. (Insert two batteries.)
4. Microcomputer version is displayed for about a second.
5. After that all segments of the liquid crystal display are turned
on.
6. Turn off the main power. (Remove two batteries.)
7. Open the solder land SL801 (TEST) on the MAIN board.
Note : The solder should be removed clean.
MAIN BOARD (SIDE B)
IC801
SL801
(TEST)
3