Black & Decker GLC2000 Manual page 10

Hide thumbs Also See for GLC2000:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
E N G L I S H
Do not store in locations where the
temperature may exceed 40 °C.
Charge only at ambient temperatures between
4 °C and 40 °C.
Charge only in a dry, well ventilated area.
Charge only using the charger provided with
the tool.
Do not attempt to charge damaged batteries.
Before charging, make sure that the battery is
dry and clean.
Use only the correct type of battery for the tool.
When disposing of batteries, follow the
instructions given in the section "Protecting
the environment".
The battery contains diluted sulphuric acid
which can be harmful. Sulphuric acid on the
skin will cause burns and if in contact with
the eyes may cause loss of sight.
In case of skin contact, flush immediately with
water. Neutralize with a mild alkaline solution
such as milk or bicarbonate of soda.
In case of eye contact, rinse abundantly with
clean water for at least 10 minutes. Seek medical
attention.
The following symbols are found on the battery:
Fire hazard! Avoid short-circuiting the
contacts of a detached battery (e.g. when
storing the battery in a toolbox).
Do not incinerate the battery.
Chargers
Use your Black & Decker charger only to
charge batteries of the type supplied with your
tool. Other batteries could burst, causing
personal injury and damage.
Have defective cords replaced immediately.
Do not expose to water.
Do not open the charger.
Do not probe the charger.
10
The following symbol is found on the charger:
Intended for indoor use only.
Additional safety instructions for grass trimmers
The following warning symbols are found on
the tool:
Wear safety glasses or goggles when
operating this tool.
The cutting line will continue to run for a
few seconds after switching the tool off.
Never attempt to force the line to come to
a standstill.
360˚
Keep people and animals at least 6 m
away from the cutting area.
Do not expose the tool to rain or high
humidity.
Wear stout shoes or boots to protect your feet.
Wear long trousers to protect your legs.
Before using the tool, check that your cutting
path is free from sticks, stones, wire and any
other obstacles.
Only use the tool in the upright position,
with the cutting line near the ground.
Never switch the tool on in any other position.
Move slowly when using the tool. Be aware
that freshly cut grass is damp and slippery.
Do not work on steep slopes. Work across the
face of slopes, not up and down.
Never cross gravel paths or roads while the
tool is running.
Never touch the cutting line while the tool
is running.
Do not put the tool down until the cutting line
has come to a complete standstill.
Use only the appropriate type of cutting line.
Never use metal cutting line or fishing line.
Be careful not to touch the line trimming blade.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents