Remington i-Light Manual page 16

■ Do not depilate (waxing, plucking, threading or creams) during the treatment – shaving is
acceptable as long as you avoid shaving 24 hours after each treatment.
■ Do not use bleaching creams or perfumed products for 24 hours after treatment.
■ Do not scratch or pick at the treated area.
Cleaning Your i-Light Device
CAUTION: Before cleaning your i-Light device, make sure that the power switch is OFF and the
power cord is disconnected from the base unit.
■ Regular cleaning helps to ensure optimal results and a long life for the i-Light device.
The exterior surface of the base unit and hand piece may be wiped clean with a slightly
damp cloth.
■ To clean the Flash Window, use only the lint-free cloth included with your i-Light device.
Take care not to scratch or chip the Flash Window. Scratches and chips can reduce the
effectiveness of the unit.
■ For stubborn stains, use a dampened cotton swab to apply a small amount of water to
the Flash Window and clean with the lint-free cloth provided.
■ Use a small hand-held vacuum to remove dust and debris from the hand piece vents.
WARNING: If the Flash Window is cracked or broken, the unit must not be used.
Never scratch the filter glass or the metallic surface inside the Nose
Cone.
CAUTION: The i-Light is a high voltage device. Never immerse in water. Never
clean the unit or any of its parts under the tap or in the dishwasher.
Do not use petroleum-based or flammable cleaning agents because
of the risk of fire. Never use scouring pads, abrasive cleaning agents
or aggressive liquids such as oil or acetone to clean the unit.
i-Light Device Maintenance
CAUTION: Before performing maintenance on your i-Light device, ensure that the
power switch is OFF and the power cord is disconnected from the base
unit.
Replacing the bulb
1. Press the nose cone release buttons and gently pull to remove the nose cone.
2. Gently pull out the old bulb cartridge.
15