Download  Print this page

Performance Accessories 4083 Installation Instructions Manual

For 98-99 nissan frontier 4 wd
Hide thumbs
   

Advertisement

INSTALLATION INSTRUCTIONS
98-99 NISSAN FRONTIER 4 WD
KIT # 4083
WARNING
Installation of a Performance Accessories body lift will
change the center of gravity and the handling
characteristics of the vehicle. Because of the higher
center of gravity and larger tires, the vehicle will handle
and react differently both on and off road. You must drive
it safely! Extreme care must be taken to prevent vehicle
rollover or loss of control, which could result in serious
injury or death. Avoid sudden sharp turns or abrupt
maneuvers and always make sure all vehicle occupants
have their seat belts fastened.
WARNING
Read and understand all instructions, warnings, cautions,
and notes in this sheet and in your owners manual before
you begin the installation of this body lift kit.
CAUTION
Proper installation of a Performance Accessories body lift
kit requires knowledge of the factory recommended
procedures for disassembly an assembly of original
equipment components. It is recommended that the
factory shop manual and any special tools necessary to
your vehicle be on hand during the installation.
Installation of this body lift kit without proper knowledge of
the factory recommended procedures may affect the
performance of these components and the safety of you
vehicle.
It is strongly recommended that a certified
mechanic who is familiar with the installation of similar
components install this body lift kit.
WARNING
This body lift kit should only be installed on vehicles that
are in good working condition. Before the installation
begins, the vehicle should be thoroughly inspected for
evidence of corrosion or deformation of the sheet metal
around the factory body mounts. This body lift kit should
not be installed on any vehicle that is suspected to have
been in a collision, or misused. Off road use of your
vehicle with this body lift installed may increase the stress
applied to the factory body mounts.
recommended that any vehicle, with a body lift installed,
be involved in any extreme off road maneuvers such as
jumping. Failure to follow this warning may result in
serious personal injury and/or serious damage to your
vehicle.
WARNING
Performance Accessories strongly discourages the use of
a suspension lift kit or any other lift device in addition to a
body lift kit. A vehicle that uses a combination of lift
devices not originally engineered to be used together may
result in unexpected and unsafe handling characteristics.
Many states now have laws restricting bumper heights
and vehicle lifts.
determine if the changes you intend to make to your
vehicle complies with state laws.
WARNING
The installation of larger wheel and tire combinations may
reduce the effectiveness of the Anti-lock Braking System.
NOTE
Performance Accessories recommends using the Loctite®
supplied in the kit, on all hardware unless noted in the
instructions.
WARNING
Always wear eye protection when operating power
tools.
1
Local laws should be consulted to
'98-'99 Frontier – Kit# 4083
It is not

Advertisement

Table of Contents
loading

  Related Manuals for Performance Accessories 4083

  Summary of Contents for Performance Accessories 4083

  • Page 1 Anti-lock Braking System. NOTE Performance Accessories recommends using the Loctite® supplied in the kit, on all hardware unless noted in the instructions. WARNING Always wear eye protection when operating power tools. It is not ’98-’99 Frontier – Kit# 4083...
  • Page 2 11. Remove two bolts that mount cab safety loop to floorboard (around driveline through the cross member). 12. Remove the two screws (one on each side) that mount the outside of the bumper to the fender. These Disconnect the ’98-’99 Frontier – Kit# 4083...
  • Page 3 Install a ½” USS washer and nylock nut on each bolt. Do not tighten at this time. 21. Repeat step # 20 for the driver’s side of the bed. Realign the bed to the cab. Refer to the measurements ’98-’99 Frontier – Kit# 4083...
  • Page 4 Using a #10 hose clamp, reconnect the large vent hose to the fuel tank. Tighten all hose clamps securely. Install the screws that mount the filler neck to the body. Tighten ’98-’99 Frontier – Kit# 4083...
  • Page 5 38. Place the warning sticker on the dash in plain sight of all vehicle occupants. CAUTION All fasteners should be retorqued after 500 miles and after off road use. All body lift components should be visually inspected and fasteners retorqued during routine vehicle servicing. ’98-’99 Frontier – Kit# 4083...
  • Page 6: Kit Parts List

    Clamp, Hose #6 Clamp, Hose #10 Clamp, Hose #28 Pin, Roll 1/8” x 1” Extension, 3” Shift Pin Hose, Vacuum Extension Tube Hose, Heater Extension Tube Hose, Extension, Fan Shroud/Heater Performance Automotive Group Rev 03, Copyright 04/06 ’98-’99 Frontier – Kit# 4083...