Silvercrest SHBS 1000 A1 Operation And Safety Notes page 74

Before first use
C onnect the cable of the plug-in mains adapter to the charging
station of the hair and beard clippers.
5
A void injury and damage to the device! Make sure that the
device is switched off before you charge the rechargeable batteries.
I nsert the plug-in mains adapter (wide voltage range 100 - 240 V)
into a mains outlet socket that meets the requirements of the device.
T he charge state indicator
red and shows the battery symbol (the symbol indicating that the
device is connected to the mains) and the value indicating the % of
the full charge achieved. After a charge state of approx. 20 % has
been achieved, the charge state indicator
and the relevant % value for the charge capacity flashes until that
charge state is achieved. The rechargeable batteries are fully charged
when the 100 % mark stops flashing and is continuously illuminated.
T he charge state indicator
completion of the charging process.
T he device can operate with fully charged batteries for up to
about 60 minutes when disconnected from the mains.
Operation with the plug-in mains adapter:
If your hair and beard clippers stop during use because of discharged
or weak rechargeable batteries, you can continue by connecting the
plug-in mains adapter.
I nsert the connector plug of the plug-in mains adapter into the
socket on the underside of the hair and beard clippers.
T o avoid injury and damage to the device, always switch off the
device before you connect it to the mains supply.
I nsert the plug-in mains adapter (wide voltage range 100 - 240 V)
into a mains outlet socket that meets the requirements of the device.
A fter 1 - 2 seconds you can switch on the device by pressing the
ON / OFF switch
74 GB/MT
on the front of the device illuminates
4
switches off a few seconds after
4
. If the device does not start working immedi-
3
changes colour to blue
4