Advertisement
Software upgrade
Preparation to upgrade software
1)
Start the CD Burning software and create a new CD
project (Data Disc) with the following setting:
Label: DVP3XXX
(No need the label name)
File Name:
DVPXXXX_XX.BIN
Power on the set and open the tray, then press <5><5>
to check the File Name.
Note: It is required capital letter for the File System
name.
2)
Burn the data onto a blank CDR
A. Procedure for software upgrade:
1)
Power on the set and insert the prepared Upgrade
CDR.
2)
The set will starts reading disc & response with the
following display TV screen:
Upgrade File DETECTED
Upgrade?
Press Play TO START.
3)
Press <OK> button to confirm, then screen will display :
Files coping...
UPGRADING...
4)
The upgraded tray will automatically open when files
coping complete, then take out the disc.
5)
About 1 minute later, the trace will automatically close
when upgrading complete.
2-1
B. Read out the software versions to confirm upgrading
1)
Power on the set and press <Setup> button on the
remote control.
2)
Press <1><3><7><9> button.
The software version and other information are display
on the TV screen as follows:
Version
XX.XX.XX.XX (Main version)
SUB-VER
XX.XX.XX.XX (software version of
8032
XX.XX.XX.XX
Servo
XX.XX.XX.XX (software version of
RISC
XX.XX.XX.XX
DSP
XX.XX.XX.XX
Region Code
Caution: The set must not be power off during
upgrading, Otherwise the Main board will be
damaged entirely.
application software)
Servo)
X
Advertisement
