Adjusting The Cutting Height - Husqvarna AUTOMOWER 315 Operator's Manual

4.7 Adjusting the cutting height

The cutting height can be varied from MIN (2 cm) to MAX
(6 cm) in nine stages.
During the first week after a new installation, the cutting
height must be set to MAX to avoid damaging the loop
wire. After this, the cutting height can be lowered one
step every week until the desired cutting height has been
reached.
If the grass is long, allow the robotic lawnmower to start
mowing at the MAX cutting height. Once the grass is
shorter, you can gradually lower the cutting height.
To adjust the cutting height:
1. Press the STOP button to stop the robotic
lawnmower,
2. Open the cutting height adjustment hatch.
3. Turn the knob to the required position. The selected
position is the marking on the body that aligns with
the arrow on the knob. Turn clockwise to increase the
cutting height. Turn counter-clockwise to decrease
the cutting height.
4. Close the hatch.
IMPORTANT INFORMATION
During the first week after a new installa-
tion, the cutting height must be set to MAX
to avoid damaging the loop wire. After
this, the cutting height can be lowered one
step every week until the desired cutting
height has been reached.
English - 38
OM_1157863-26_HQ 310,315,EN_160229.indd 38
USE
3012-1381
3012-1348
3012-1303
2016-02-29 10:51:59