Husqvarna AUTOMOWER 315 Operator's Manual page 25

Working area boundaries
If a high obstacle (5 cm or more), for example a wall
or fence, borders the working area, the boundary wire
should be laid 35 cm from the obstacle. This will prevent
the robotic lawnmower from colliding with the obstacle
and reduce body wear.
About 20 cm of the lawn around the fixed obstacle will not
be mown.
If the working area borders on a small ditch, for example
a flower bed or a small elevation, for example a low
kerbstone (1-5 cm), the boundary wire should be laid
30 cm inside the working area. This prevents the wheels
from driving into the ditch or up onto the kerbstone
which might be lead to excessive wear on the robotic
lawnmower, and especially the front wheels.
About 15 cm of the lawn along the ditch/kerbstone will not
be mown.
If the working area borders on a paving stone path or
similar that is level with the lawn (+/- 1 cm), it is possible
to allow the robotic lawnmower to run a little over the
path. The boundary wire should then be laid 10 cm from
the edge of the path.
All the grass along the side of the paving stone path will
be cut.
When the working area is divided by a paving stone path
that is level with the lawn, it is possible to allow the robotic
lawnmower to run over the path. It can be an advantage
to lay the boundary wire under the paving stones. The
boundary wire can also be laid in the joint between the
paving stones. Ensure that the tiles are in level with the
lawn to avoid excessive wear on the robotic lawnmower.
Note:
The robotic lawnmower must never run over gravel,
mulch or similar material which can damage the blades.
IMPORTANT INFORMATION
If the working area is adjacent to water
bodies, slopes, precipices or a public
road, the boundary wire must be supple-
mented with an edging or the like. It must
then be at least 15 cm in height. This will
prevent the robotic lawnmower from end-
ing up outside the working area under any
circumstance.
OM_1157863-26_HQ 310,315,EN_160229.indd 23
INSTALLATION
3012-1111
3012-1112
3012-1113
3012-1114
Min.
15cm/16"
3018-046
English - 23
2016-02-29 10:51:45