Searching For A Device Code; Locking The Volume Keys; Clearing The Remote's Programming; Resetting To The Factory Default - Toshiba 42SL417U Owner's Manual

Searching for a device code

If you do not know the device code for a particular
device, you can view each available code for that device
mode and sample the functions to find the code that
operates the target device.
1
Press a mode select button on the remote.
While holding down Q, press 8, 5, 0, 0. The
2
remote control enters program mode.
3
Point the remote at the target device. Press
, , or
VOL CH
code.
4
If the device responds to the remote control:
Press Q to store the device code. The remote exits
program mode.
5
If the device does not respond to the remote control:
Repeat this step until the device responds to the
remote.
When no code is found, exit the program mode by
the following operation:
Press Q. (current state is stored)
•
Press no key for 10 seconds. (current state is not
•
stored)
Note: When a search cycle is completed, the remote
displays each available code again. If no key is pressed
within 10 seconds, the remote exits program mode and
returns to the previous code.

Locking the volume keys

The remote's volume keys (
locked to a device mode.
State
Locked (default)
Unlocked
Locked to a
specific device
mode
See "Operating other devices" (- p. 79).
80
Downloaded from www.Manualslib.com
, and then press B or b to change a
, VOL , and MUTE) are
VOL
Meaning
The remote operates the TV's volume
except the AUX mode, even when the
TV is not the current device mode.
The remote operates the volume of
the device associated with the current
device mode.
Each device mode has its own volume
(if the device ID has volume data).
The remote operates the volume of
the device associated with the locked
mode, even when the locked mode is
not the current device mode.
Note: The AUX mode is not locked to
other device modes.
manuals search engine
Chapter 10: Appendix
To lock the remote's volume keys to a specific mode:
Example: CABLE/SAT mode
1
Press CABLE/SAT.
While holding down Q, press 8, 0, 0, 0.
2
3
Press
VOL
The remote's volume keys now operate the volume
of the device associated with the CABLE/SAT
mode, even when CABLE/SAT is not the current
device mode.
POWER
, 1,
To unlock the remote's volume keys:
While holding down Q, press 8, 0, 0, 0.
1
2
Press VOL

Clearing the remote's programming

You can clear all programmed remote control features
not related to "Device code setup" and reset the volume
lock to the TV device mode.
While holding down Q, press 8, 9, 0, 0.

Resetting to the factory default

You can clear changed manufacturing features.
While holding down Q, press 8, 9, 0, 1.
(locked).
. The CABLE/SAT mode is unlocked.