Connect The Telephone Cord / Test The Connection / Installing The Belt Clip - Uniden XDECT 8015WP series Owner's Manual

Connect the Telephone Cord
Use the telephone cord to connect the
jack to a standard telephone wall jack.
TEl lINE
Test the connection
1) Pick up the handset from the cradle and press
should hear a dial tone, and the display should say Talk.
If...
you don't hear a dial tone or the
display says Check Tel Line
2) Make a quick test call. (Press
If...
there's a lot of noise or static
3) Test any accessory handsets the same way. If you can't get a
dial tone or the handset display says Unavailable, try moving the
handset closer to the base or resetting it (see page 27). Charge
all handsets completely (about 15 hours) before using them.
Installing the belt Clip
Line up the holes on each side of the handset. To attach the belt
clip, insert into the holes on each side of the handset. Press down
until it clicks. To remove the belt clip, pull either side of the belt clip
to release the tabs from the holes.
Try...
checking the connection between
the base and the phone jack.
END to hang up.)
Try...
see page 25 for tips on avoiding
interference.
Talk/flaSh. You
7