Table of Contents
Advertisement
ENGLISH
SPECIFICATIONS
Depressed center wheel diameter
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
SAFETY INSTRUCTIONS
WARNING! When using electric tools, basic safety
precautions, including the following, should always
be followed to reduce the risk of fire, electric shock
and personal injury. Read all these instructions
before operating this product and save these
instructions.
For safe operations:
1.
Keep work area clean.
Cluttered areas and benches invite injuries.
2.
Consider work area environment.
Do not expose power tools to rain. Do not use
power tools in damp or wet locations. Keep work
area well lit. Do not use power tools where there is
risk to cause fire or explosion.
3.
Guard against electric shock.
Avoid body contact with earthed or grounded
surfaces
(e.g.
refrigerators).
4.
Keep children away.
Do not let visitors touch the tool or extension cord.
Model
Spindle thread
-1
)
Overall length
Net weight
pipes,
radiators,
END101-1
All visitors should be kept away from work area.
5.
Store idle tools.
When not in use, tools should be stored in a dry,
high or locked up place, out of reach of children.
6.
Do not force the tool.
It will do the job better and safer at the rate for
which it was intended.
7.
Use the right tool.
Do not force small tools or attachments to do the
ENE048-1
job of a heavy duty tool. Do not use tools for
purposes not intended; for example, do not use
circular saws to cut tree limbs or logs.
ENF002-1
8.
Dress properly.
Do not wear loose clothing or jewellery, they can
be caught in moving parts. Rubber gloves and
non-skid
working outdoors. Wear protecting hair covering
to contain long hair.
9.
Use safety glasses and hearing protection.
Also use face or dust mask if the cutting operation
ENA001-2
is dusty.
10. Connect dust extraction equipment.
If devices are provided for the connection of dust
extraction and collection facilities ensure these
are connected and properly used.
11.
Do not abuse the cord.
Never carry the tool by the cord or yank it to
disconnect it from the socket. Keep the cord away
from heat, oil and sharp edges.
12. Secure work.
Use clamps or a vice to hold the work. It is safer
than using your hand and it frees both hands to
operate the tool.
13. Do not overreach.
Keep proper footing and balance at all times.
14. Maintain tools with care.
Keep cutting tools sharp and clean for better and
safer
lubrication and changing accessories. Inspect tool
ranges,
cord periodically and if damaged have it repaired
by an authorized service facility. Inspect extension
cords periodically and replace, if damaged. Keep
2
9500N
100 mm
M10
12,000
245 mm
1.65 kg
footwear
are
recommended
performance.
Follow
when
instructions
for
Advertisement
Table of Contents
