Sony STR-DH720 Service Manual page 2

Multi channel av receiver
Hide thumbs Also See for STR-DH720:
Table of Contents

Advertisement

STR-DH720/DH720HP
FM tuner section
Tuning range
87.5 MHz – 108.0 MHz
Antenna (aerial)
FM wire antenna (aerial)
Antenna (aerial) terminals 75 ohms, unbalanced
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
Area
Tuning scale
10 kHz step 9 kHz step
US, CND
530 kHz –
1,710 kHz
ECE
Antenna (aerial)
Loop antenna (aerial)
Intermediate frequency
450 kHz
Video section
Inputs/Outputs
Video:
1 Vp-p/75 ohms
COMPONENT VIDEO:
Y: 1 Vp-p, 75 ohms
P
: 0.7 Vp-p, 75 ohms
B
P
: 0.7 Vp-p, 75 ohms
R
80 MHz HD Pass Through
iPhone/iPod section
DC 5V 1.0 A MAX
USB section
Supported bit rate*
MP3 (MPEG 1 Audio Layer-3):
32 kbps - 320 kbps,VBR
WMA: 48 kbps - 192 kbps
AAC: 48 kbps - 320 kbps
*Compatibility with all encoding/writing software,
recording devices and recording media cannot be
guarantee.
Transfer speed
Full-speed
Supported USB device
Mass Storage Class
Maximum current
500 mA
General
Power requirements
Area code
Power requirements
US, CND
120 V AC, 60 Hz
ECE
230 V AC, 50/60 Hz
Power consumption
240 W
Power consumption (during standby mode)
0.3 W (When "Ctrl for HDMI" is set to "OFF")
Dimensions (width/height/depth) (Approx.)
430 mm × 157.5 mm × 322 mm (17 in × 6 1/4 in ×
12 3/4 in) including projecting parts and controls
Mass (Approx.)
8.0 kg (17 lb 11 oz)
Design and specifi cations are subject to change without notice.
Halogenated fl ame retardants are not used in the certain printed wiring
boards.
Supplied accessories
Operating Instructions
Quick Setup Guide
GUI Menu List
FM wire antenna (aerial) (1)
AM loop antenna (aerial) (1)
2
531 kHz –
1,710 kHz
531 kHz –
1,602 kHz
Remote commander (1)
– RM-AAU106 (US and CND models only)
– RM-AAU107 (Other models)
R6 (size AA) batteries (2)
Optimizer microphone (ECM-AC2) (1)
Abbreviation
CND : Canadian model
ECE : Continental European, East European and Russian models
SAFETY CHECK-OUT (US MODEL)
After correcting the original service problem, perform the following safety
check before releasing the set to the customer:
Check the antenna terminals, metal trim, "metallized" knobs, screws, and
all other exposed metal parts for AC leakage.
Check leakage as described below.
LEAKAGE TEST
The AC leakage from any exposed metal part to earth ground and from
all exposed metal parts to any exposed metal part having a return to chas-
sis, must not exceed 0.5 mA (500 microamperes.). Leakage current can be
measured by any one of three methods.
1. A commercial leakage tester, such as the Simpson 229 or RCA WT-
540A. Follow the manufacturers' instructions to use these instruments.
2. A battery-operated AC milliammeter. The Data Precision 245 digital
multimeter is suitable for this job.
3. Measuring the voltage drop across a resistor by means of a VOM or
battery-operated AC voltmeter. The "limit" indication is 0.75 V, so
analog meters must have an accurate low-voltage scale. The Simp-
son 250 and Sanwa SH-63Trd are examples of a passive VOM that
is suitable. Nearly all battery operated digital multimeters that have a
2 V AC range are suitable. (See Fig. A)
To Exposed Metal
Parts on Set
0.15 μF
Fig. A. Using an AC voltmeter to check AC leakage.
SAFETY-RELATED COMPONENT WARNING!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS
WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR
LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES
P I È C E S S O N T C R I T I Q U E S P O U R L A S É C U R I T É D E
FONCTIONNEMENT. NE REMPLACER CES COMPOSANTS
QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT
DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉ-
MENTS PUBLIÉS PAR SONY.
AC
1.5 kΩ
voltmeter
(0.75 V)
Earth Ground

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Str-dh720hp

Table of Contents